Daikin FTX25JAV1NB [29/29] With a multi indoor unit install as described in the installation manual supplied with the multi outdoor unit

Daikin FTX35JAV1NB [29/29] With a multi indoor unit install as described in the installation manual supplied with the multi outdoor unit
11
Installation
j
A
Mounting plate
The mounting plate should be
installed on a wall which can
support the weight of the indoor
unit.
Mounting plate
Indoor/outdoor unit installation drawings
30mm or more from ceiling
Front grille
50 mm or more from walls
(on both side)
Service lid
This service lid is an open/close type.
+
Remove the screws on the service lid.
+
Slide the service lid leftward.
+
Rotate the service lid upward.
Caulk pipe hole
gap with putty.
Cut thermal insulation pipe to
an appropriate length and
wrap it with tape, making sure
that no gap is left in the
insulation pipe’s cut line.
Wrap the installation pipe with the
finishing tape from bottom to top
Model 25 class 35 class 50 class 60 class
Max. allowable length Cooling only: 25m
See the installation manual supplied
with the Multi outdoor unit.
Max. allowable height 15m
Additional refrigerant required for
refrigerant pipe exceeding 10 m in
length.
20 g/m
Gas pipe O.D. 9.5 mm O.D. 12.7 mm O.D. 15.9 mm O.D. 15.9 mm
Liquid pipe O.D. 6.4 mm
* Be sure to add the proper amount of additional refrigerant. Failure to do
so may result in reduced performance.
With a Multi indoor unit, install as described in the installation manual
supplied with the Multi outdoor unit.
j
C
Air purification filters
j
D
Infrared remote
control
j
2
Push
Before screwing the remote
control holder to the wall,
make sure that control
signals are properly received
by indoor unit.
j
1
Insert
j
E
Remote control holder
In sites with poor drainage, use block bases for
outdoor unit. Adjust foot height until the unit is
leveled. Otherwise, water leakage or pooling of
water may occur.
Where there is a danger of the unit falling, use
foot bolts, or wires.
Allow space for piping and electrical
servicing.
Service lid
How to remove the service lid.
+
This service lid is an open/close type.
+
Slide the lid downward to remove it.
How to attach the service lid.
+
Insert the upper part of the service lid into the
outdoor unit to install.
+
Tighten the screws.
Air filters
How to attach the indoor unit.
Hook the claws of the bottom frame to the
mounting plate.
If the claws are difficult to hook, remove the
front panel.
How to remove the indoor unit.
Push up the marked area (at the lower part of
the front panel) to release the claws. If it is
difficult to release, remove the front panel.
Foot bolt-hole
centres
Foot bolt-hole
centres
From unit’s side
j
B
M4 x 25L
j
F
(M3 x 20L)
Install air purification filter on air
filter
Air filter
Air purification filters
Clip
Mark (rear side)Bottom frame
Front panel
250 mm from wall
Wall Mounted Inverter Controlled Unit
R-22
FTK/FTX-JA/FTX-H/FTXD-J
2
11
27
Split - Sky Air Indoor Units

Содержание