Sinbo SSI 2858 [10/48] Spraying

- 9 -

SPRAYING

This function can be used any time and it dose not affect the ironing temperature.

• Fill water into the iron.

• Aim the nozzle towards the garment.

• Press the Spray Button (3)

STEAM IRONING

This function can be used only at higher ironing temperature.

For moderate steam or MAX for maximum steam

• Fill water into the iron.

• Stand the iron upright.

• Connect the iron to a suitable mains supply outlet.

• Turn the temperature control (l) to the "••"."•••" or MAX setting.

• The pilot light turns off when the required temperature is reached the iron is ready

for use.

• Turn the steam knob (7) to the required position, steam starts coming

out form the holes in the sole plate.

Notice: With conventional steam ironing, water may leak form the sol plate if too low

a temperature has been select. If this happens, turn the temperature control (1) to the

advised position. Steam will recommence as soon as the appropriate temperature has

be reached.

BURST OF STEAM

This function provides an extra amount of steam to remove stubborn wrinkles.

• Fill the iron with water.

• Turn the temperature control to the position "MAX"

• The iron is ready for use

• Press the Burst of Steam button (2) once

• Steam will penetrate into the garment removing the wrinkles

• Wait a few seconds before pressing the steam control knob again when there are

stubborn wrinkles

Usually all wrinkles can be removed within three pressings

DRY IRONING

• Connect the iron to a suitable mains supply outlet

• Ensure that the steam control knob (7) is in position"0"

• Select the setting on the temperature control (1).

• When the pilot light turns off, the required temperature is reached. The iron is ready

for use.

TO LET THE IRON HEAT UP AGAIN:

Pick up the iron or move it slightly