Tecnoclima BESST/R 21 [4/40] General directions

IDENTIFICATION

The unit can be identified through:

- - Rating plate

It bears the technical and performance data of the equipment.

Should this plate be damaged or mislaid, ask your local Technical Support Service for a duplicate.

Tampering with the rating plate, removing it or whatever else does not allow a sure identification of the product hinder

any installation or maintenance interventions.

GENERAL DIRECTIONS

After unpacking the appliance, check it for integrity and completeness. Should the content not match your order, please contact the retailer

who sold the equipment.

The equipment must be installed by a qualified company which, at the end of the work, must provide the proprietor with a declaration of

conformity stating that the installation complies with the best practice and the applicable national and local regulations, as well as the

indications of this instruction manual.

These appliances were made for room air heating and/or conditioning and must be destined for this use consistently with their performance

characteristics.

The manufacturer does not assume any contractual or extra-contractual liability for damages caused to people, animals or things by

installation, adjustment and maintenance errors or improper use.

In case of water leakage, turn OFF the main system circuit breaker and close the water taps.

Immediately call the Technical Support Service or professionally qualified personnel and do not personally intervene on the equipment.

The appliance contains refrigerant gas R 410A; act carefully in order not to damage the gas circuit and the finned coil. In case of refrigerant

leakage, turn OFF the main system circuit breaker. Immediately call the Technical Support Service or professionally qualified personnel and

do not personally intervene on the equipment.

The appliances must be exclusively equipped with original accessories. The manufacturer is not responsible for any damages resulting from

the improper use of the appliance and the use of non-original accessories and materials.

The references to laws, regulations, directives and technical standards mentioned in this manual have a mere informational purpose and are

valid at the printing date of the same. The manufacturer cannot be bound towards third parties on account of new regulations or

amendments to those already in force.

The installations to be made (gas piping, electric power supply, etc.) must be adequately fixed and avoid the risk of stumbling.

The manufacturer is responsible for the conformity of his product to the laws, directives and standards which were in force at the time of

marketing.

The knowledge and observance of regulations and standards about the system designing, installation, operation and maintenance are at the

exclusive charge of the designer, installer and user according to their spheres of competence.