Zelmer 616 [126/128] Filter replacement

Zelmer 616 [126/128] Filter replacement
126
Exhaust air lter
The exhaust air lter should be replaced upon about 30 hours of operation
(6 months) or earlier in case it gets very dirty.
Press the blockade and open the exhaust cover.
Replace the lter (1 and 2):
FILTER REPLACEMENT
In the course of the operation the inlet and exhaust air lters get dirty. To ensure proper operation of the
vacuum cleaner it is recommended to rinse the inlet lter frequently. A very dirty or damaged inlet lter has
to be replaced with a new one.
Inlet lter
Model: 616.*E – Fig.A – Electro lter
Position the new lter thoroughly so that the frame edges stick tightly to
the rim of the lter.
Model: 616.*S – Fig.B – HEPA Filter cartridge
Upon going though the turbines this foam condenses then on the exhaust lter. To avoid this you
should add an anti-foam agent recommended by ZELMER S.A. to the front container and to turn on
the vacuum cleaner (without the front container) for a few minutes to let the suction system dry.
The exhaust air lter shall always be replaced with a genuine brand-new one.
Open the upper cover and set it to a vertical position.
Seize the top edge of the lter with your ngers and pull it slightly towards you until
it pulls out from the clamps.
Rotate the frame, take the lter out, rinse it with running water wringing it out slightly,
dry it and set in place (or replace with a new one).
Position the new lter thoroughly so that the frame edges stick tightly to the rim of
the lter.
Close the cover.
instrukcja 616-010.indb 126instrukcja 616-010.indb 126 2008-09-18 16:03:212008-09-18 16:03:21

Содержание