Sony PS-LX330 [5/8] Connections

Содержание

• Manual de instrucciones 1
• Operating instructions 1
• Sony_ps lx330_en 1 1
• Stereo turntable system 1
• Oooo oooo 2
• Sony_ps lx330_en 2 2
• Features 3
• Precautions 3
• Sony_ps lx330_en 3 3
• Table of contents 3
• Warning 3
• Operating voltage parts identification 4
• Sony_ps lx330_en 4 4
• Connections 5
• Sony_ps lx330_en 5 5
• Tips on record handling 5
• Turntable assembly 5
• Auto play 6
• Manual play to begin record play at a par ticular point 6
• Preparation 6
• Record playing 6
• Sony_ps lx330_en 6 6
• To lift up the stylus during play 6
• To stop during play 6
• Auto record size selection system 7
• Replacing the stylus 7
• Sony_ps lx330_en 7 7
• To repeat play 7
• Design and specifications subject to change without notice 8
• Groove skipping tonearm tends to skate tonearm does not advance improper setting of the anti skating compensator the turntable is not placed on a level surface defective record external vibrations 8
• Impaired tone quality dusty stylus the turntable is not placed on a level surface the turntable is incorrectly placed on or too near a speaker worn stylus or defective record the stylus life is approximately 400 hours of playing time incorrect stylus installation improper setting of the anti skating compensator 8
• Loud rumble or low frequency howl the turntable is affected by external vibration the turntable is too near a speaker 8
• No audio from one channel loose connection of phono connecting cord low volume level setting for one channel of the amplifier 8
• Sony_ps lx330_en 8 8
• Specifications trouble checks 8
• Steady low pitched hum loose connection of phono cord 8
• Synchronized operation cannot be made set the sync switch on the rear panel to on the supplied flat cord is not connected firmly to the system control connector the cable connector and ground wire are not con nected firmly to the amplifier 8
• The following trouble checks will help you correct most common problems encountered with a turntable system should any problem persist after you have made these checks consult your nearest sony service facility before proceeding with these trouble checks first refer to the connections and the operating procedures 8

Похожие устройства

• Sony PS-LX330P Service Manual
• Sony PS-LX330P Инструкция по использованию
• Foodatlas SF-B300 Инструкция по эксплуатации
• Foodatlas SF-B300 Сертификат
• Sony RDR-HX510 Инструкция по использованию
• Sony RDR-HX710 Инструкция по использованию
• Sony RDR-HX910 Инструкция по использованию
• Technics SL-PG390 Service Manual
• LG DR4912 Инструкция по использованию
• Panasonic SL-CT720EE-S Инструкция по использованию
• Ambertek MD80 Инструкция по использованию
• Foodatlas SF-B500 Инструкция по эксплуатации
• Foodatlas SF-B500 Сертификат
• Foodatlas SF-B600 Инструкция по эксплуатации
• Foodatlas SF-B600 Сертификат
• Foodatlas SF-B700 Инструкция по эксплуатации
• Foodatlas SF-B700 Сертификат
• Foodatlas SF-B800 Инструкция по эксплуатации
• Foodatlas SF-B800 Сертификат
• Foodatlas SF-B900 Инструкция по эксплуатации

CONNECTIONS Rear panel See the connection diagram on page 3 SYNC switch Set to ON for synchronized play with the tape deck of the optional Sony LBT V33 V33W or LBT V11 V11W stereo component system Set to OFF when synchroniz ed play is not required Turn off the amplifier before making connections Be sure to connect the red plug of the connecting cord to the right R jack and the remaining one to the left L The cable connectors should be fully inserted into the jacks A loose connection may cause hum and noise Leave a little slack in the connecting cord to allow for inadvertent shock or vibration For customers supplied with a plug adaptor if necessary use the plug adaptor to connect the turntable to an ac outlet in the house However when making power connections among the Sony components this adaptor is not needed To use the unit with the optional Sony LBT V33 V33W or LBT V11 V11W stereo component system connect the stereo component system and SYSTEM control con nector of the PS LX330 with the supplied flat cord 10 pin SYSTEM control connector 10 pin Connect to the PHONO connector of the amplifier of the Sony optional LBT V33 V33W or LBT V11 V11W stereo component system for direct function remote control operation only with LBT V33 V33W and synchronized play TURNTABLE ASSEMBLY Do not connect the power cord or the connecting cords until the turntable has been completely assembled Remove all packing material and wipe the cabinet off Save the packing box and materials for possible future use 1 Keep the metallic parts indicated by the arrows in the illustration inside the large white gear 2 Set the platter on the motor board while holding the belt as shown in the illustration and hook the belt on the motor pulley 3 Place the rubber mat on the platter so that the holes for auto record size selection on the rubber mat and on the platter are matched correctly 6 TIPS ON RECORD HANDLING Before playing clean the record with a record cleaner or soft cloth If a spray cleaner is used make sure that it has dried completely before playing the record Handle a record by its edges and do not touch the grooves Use a commercially available anti static spray to neutralize the static electricity on a record Avoid exposing a record to direct sunlight or sources of heat such as a hot air duct Store your records vertically They should not be com pressed