Sony PS-LX330 [6/8] Record playing

Содержание

• Manual de instrucciones 1
• Operating instructions 1
• Sony_ps lx330_en 1 1
• Stereo turntable system 1
• Oooo oooo 2
• Sony_ps lx330_en 2 2
• Features 3
• Precautions 3
• Sony_ps lx330_en 3 3
• Table of contents 3
• Warning 3
• Operating voltage parts identification 4
• Sony_ps lx330_en 4 4
• Connections 5
• Sony_ps lx330_en 5 5
• Tips on record handling 5
• Turntable assembly 5
• Auto play 6
• Manual play to begin record play at a par ticular point 6
• Preparation 6
• Record playing 6
• Sony_ps lx330_en 6 6
• To lift up the stylus during play 6
• To stop during play 6
• Auto record size selection system 7
• Replacing the stylus 7
• Sony_ps lx330_en 7 7
• To repeat play 7
• Design and specifications subject to change without notice 8
• Groove skipping tonearm tends to skate tonearm does not advance improper setting of the anti skating compensator the turntable is not placed on a level surface defective record external vibrations 8
• Impaired tone quality dusty stylus the turntable is not placed on a level surface the turntable is incorrectly placed on or too near a speaker worn stylus or defective record the stylus life is approximately 400 hours of playing time incorrect stylus installation improper setting of the anti skating compensator 8
• Loud rumble or low frequency howl the turntable is affected by external vibration the turntable is too near a speaker 8
• No audio from one channel loose connection of phono connecting cord low volume level setting for one channel of the amplifier 8
• Sony_ps lx330_en 8 8
• Specifications trouble checks 8
• Steady low pitched hum loose connection of phono cord 8
• Synchronized operation cannot be made set the sync switch on the rear panel to on the supplied flat cord is not connected firmly to the system control connector the cable connector and ground wire are not con nected firmly to the amplifier 8
• The following trouble checks will help you correct most common problems encountered with a turntable system should any problem persist after you have made these checks consult your nearest sony service facility before proceeding with these trouble checks first refer to the connections and the operating procedures 8

Похожие устройства

• Sony PS-LX330P Service Manual
• Sony PS-LX330P Инструкция по использованию
• Foodatlas SF-B300 Инструкция по эксплуатации
• Foodatlas SF-B300 Сертификат
• Sony RDR-HX510 Инструкция по использованию
• Sony RDR-HX710 Инструкция по использованию
• Sony RDR-HX910 Инструкция по использованию
• Technics SL-PG390 Service Manual
• LG DR4912 Инструкция по использованию
• Panasonic SL-CT720EE-S Инструкция по использованию
• Ambertek MD80 Инструкция по использованию
• Foodatlas SF-B500 Инструкция по эксплуатации
• Foodatlas SF-B500 Сертификат
• Foodatlas SF-B600 Инструкция по эксплуатации
• Foodatlas SF-B600 Сертификат
• Foodatlas SF-B700 Инструкция по эксплуатации
• Foodatlas SF-B700 Сертификат
• Foodatlas SF-B800 Инструкция по эксплуатации
• Foodatlas SF-B800 Сертификат
• Foodatlas SF-B900 Инструкция по эксплуатации

RECORD PLAYING PREPARATION Place a record on the platter For 17 cm 7 inch records put the supplied 45 rpm adaptor over the center spindle Lower the amplifier volume and set the input selector to PHONO Set the SYNC switch on the rear of the turntable to OFF if synchronized play with the cassette deck is not required 3 To move the drop point inward turn the screw clockwise To move the drop point outward turn the screw counterclockwise Be sure not to turn screw counterclockwise so far that the stylus tip cannot make contact with the record AUTO PLAY 1 Press the POWER switch n ON 2 Select the correct record speed 3 Set the cueing lever to the 5 position 4 Unlock the arm rest latch and remove the stylus guard 5 Press the START STOP key When the tonearm reaches the end of the record it will automatically return to the arm rest Press the POWER switch to turn the unit off after the tonearm returns to the arm rest Notes 25 cm 10 in records and transparent records cannot be played automatically To play these records turn the rubber mat so that the auto record size selection holes are covered and proceed as in MANUAL PLAY on this page Do not turn the POWER switch off while playing The tonearm will remain on the record and the stylus and the record will be damaged If the POWER switch is turned off while the tonearm is returning to the arm rest the tonearm will stop at that point and will continue returning to the arm rest when the POWER switch is turned on the next time While the tonearm is returning the START STOP key does not ac tivate the record playing At first playing or after when the turntable has been subjected to strong vibration or shock the record size selection may malfunction as follows The tonearm may lower onto the platter when the START STOP key is pressed even if there is no record on the platter The tonearm may lower on the point for a 17 cm record even if the 30 cm record size has been selected If this happens press the START STOP key to return the tonearm to the arm rest and press the button again to restart play Tonearm drop point adjustment The tonearm s drop point during auto play has been ad justed at the factory If this needs to be readjusted pro ceed as follows 1 Be sure that the POWER switch is turned off and the tonearm is secured to the arm rest 2 Insert a screwdriver into the tonearm drop point hole 4 Start auto play and check that the stylus lowers at the correct drop point If the drop point is correct for 30 cm 12 in record it will also be correct for 17 cm 7 in records MANUAL PLAY To begin record play at a par ticular point 1 Press the POWER switch n ON 2 Select the correct record speed 3 Set the cueing lever to the position 4 Unlock the arm rest latch and remove the stylus guard 5 Bring the tonearm to the point over the record at which you want to start play 6 Press the START STOP key When the tonearm reaches the end of the record it will automatically return to the arm rest Press the POWER switch to turn the unit off after the tonearm returns to the arm rest Note If you bring the tonearm too near the record label the tonearm may move slightly outwards as a result of hav ing activated the automatic return mechanism TO LIFT UP THE STYLUS DURING PLAY Set the cueing lever to V To start playing from the same point set the cueing lever to V To start playing from a different part of the record move the tonearm by hand to the desired point of the record then set the cueing lever to V TO STOP DURING PLAY Press the START STOP key The tonearm will lift up and automatically return to the arm rest