Sony PS-LX330P [7/8] Auto record size selection system

Содержание

• Manual de instrucciones 1
• Operating instructions 1
• Sony_ps lx330_en 1 1
• Stereo turntable system 1
• Oooo oooo 2
• Sony_ps lx330_en 2 2
• Features 3
• Precautions 3
• Sony_ps lx330_en 3 3
• Table of contents 3
• Warning 3
• Operating voltage parts identification 4
• Sony_ps lx330_en 4 4
• Connections 5
• Sony_ps lx330_en 5 5
• Tips on record handling 5
• Turntable assembly 5
• Auto play 6
• Manual play to begin record play at a par ticular point 6
• Preparation 6
• Record playing 6
• Sony_ps lx330_en 6 6
• To lift up the stylus during play 6
• To stop during play 6
• Auto record size selection system 7
• Replacing the stylus 7
• Sony_ps lx330_en 7 7
• To repeat play 7
• Design and specifications subject to change without notice 8
• Groove skipping tonearm tends to skate tonearm does not advance improper setting of the anti skating compensator the turntable is not placed on a level surface defective record external vibrations 8
• Impaired tone quality dusty stylus the turntable is not placed on a level surface the turntable is incorrectly placed on or too near a speaker worn stylus or defective record the stylus life is approximately 400 hours of playing time incorrect stylus installation improper setting of the anti skating compensator 8
• Loud rumble or low frequency howl the turntable is affected by external vibration the turntable is too near a speaker 8
• No audio from one channel loose connection of phono connecting cord low volume level setting for one channel of the amplifier 8
• Sony_ps lx330_en 8 8
• Specifications trouble checks 8
• Steady low pitched hum loose connection of phono cord 8
• Synchronized operation cannot be made set the sync switch on the rear panel to on the supplied flat cord is not connected firmly to the system control connector the cable connector and ground wire are not con nected firmly to the amplifier 8
• The following trouble checks will help you correct most common problems encountered with a turntable system should any problem persist after you have made these checks consult your nearest sony service facility before proceeding with these trouble checks first refer to the connections and the operating procedures 8

Похожие устройства

• Foodatlas SF-B300 Инструкция по эксплуатации
• Foodatlas SF-B300 Сертификат
• Sony RDR-HX510 Инструкция по использованию
• Sony RDR-HX710 Инструкция по использованию
• Sony RDR-HX910 Инструкция по использованию
• Technics SL-PG390 Service Manual
• LG DR4912 Инструкция по использованию
• Panasonic SL-CT720EE-S Инструкция по использованию
• Ambertek MD80 Инструкция по использованию
• Foodatlas SF-B500 Инструкция по эксплуатации
• Foodatlas SF-B500 Сертификат
• Foodatlas SF-B600 Инструкция по эксплуатации
• Foodatlas SF-B600 Сертификат
• Foodatlas SF-B700 Инструкция по эксплуатации
• Foodatlas SF-B700 Сертификат
• Foodatlas SF-B800 Инструкция по эксплуатации
• Foodatlas SF-B800 Сертификат
• Foodatlas SF-B900 Инструкция по эксплуатации
• Foodatlas SF-B900 Сертификат
• Foodatlas SF-B600 (транс-р справа) Инструкция по эксплуатации

TO REPEAT PLAY Press the REPEAT button either before or after starting play To cancel repeat play press the REPEAT button again To stop during repeat play press the START STOP key Note Transparent records and 25 cm 10 in records cannot be played repeatedly REPLACING THE STYLUS The stylus will lose its effectiveness and begin to damage records after about 400 hours of use An ND 143G replacement stylus is available at your Sony dealer Handle the stylus carefully as it is very delicate Install the replacement stylus as follows 1 Lower the sound level or turn the amplifier off 2 Secure the tonearm to the arm rest 3 While holding the tonearm pipe with your hand detach the stylus assembly as illustrated 4 Insert the new stylus into the cartridge AUTO RECORD SIZE SELECTION SYSTEM The auto record size selection system which only works during auto play serves to detect using a beam from the lamp and the photo detectors whether there is a record or not on the platter and also to determine the record size When a 30 cm record is to be played both inner and outer holes are covered so no beam is transmitted to the photo detectors When a 17 cm record is to be played the inner holes are covered so a beam is transmitted through the outer holes to the photo detector When there is no record on the platter a beam is transmitted through both the inner and outer holes to the photo detectors Even if the START STOP key is ac cidentally pressed the tonearm does not lower When a 25 cm record is to be played the tonearm lowers to the same point that it would if a 17 cm record were on the platter since the inner holes are covered To play a 25 cm record cover the auto record size selection holes by rotating the rubber mat and proceed as in MANUAL PLAY At the end of the record the tonearm will automatically return to the arm rest When a transparent record is to be played a beam passes through both the inner and outer holes to the detectors so the tonearm does not lower onto the record To play a transparent record cover the autorecord size selection holes by rotating the rubber mat 180 and proceed as in MANUAL PLAY When a badly warped record is to be played a beam may pass through the holes to the detector s and cause a malfunction of the auto record size selection To play a warped record cover the auto record size selection holes by rotating the rubber mat 180 and pro ceed as in MANUAL PLAY Note Certain records allow the beam to pass through although they appear opaque These records should also be played manually