Mongoose Cyborg Start [12/14] Cyborg start

Two Way Car Alarm System MONGOOSE CYBORG START

ENGLISH

 Start the engine using the ignition key and the alarm system will monitor the Engine RPM

signal.

 When the engine has reached the idle speed, press button 3 within 3seconds of pressing

button 5 to start the idle frequency learning.

 The system will monitor the engine RPM signal for 3seconds and save the average

frequency during this period as the idle frequency.

 Once the RPM Signal has been learnt, the system will automatically exit learning mode

beeping the siren unit and flashing the indicators 3 times to indicate that the RPM signal

has been learnt. The system will return to the Installer Software Switch Table at

switch 27 RPM Learning (you can use the override switch to move up and down the

installer switches as normal)

Notes:

 If the you tried to start the car during RPM learning mode and the engine does not start,

then the 1minute learning timer will be reset when the starter motor is switched off.

 If the system remains in learning mode for 1minute without a (a further) attempt to start

the vehicle being made, the system will exit RPM learning mode, beep the siren and flash

the indicators 4 times and return to Installer Software Switch 27 RPM Learning.

 If the system reads an engine RPM signal but is unable to learn the frequency of the signal,

the system will exit learning mode 1minute after the engine was started and return to

Installer Software Switch 27 RPM Learning beeping the siren and flashing the indicators

5 times to indicate that the signal could not be learnt.

 RPM Remote Start cannot be used unit an Idle Engine RPM signal has been taught to the

system – i.e. you must select Installer Software Switch 27 RPM Learning and complete the

procedure above with a 3flash/3beep confirmation being given by the system before Remote

Start will function.

 After the RPM Leaning has been completed the Voltage sensing and the Generator/Oil

Lamp Sensing will be unavailable until the RPM Learning is canceled.

Canceling of the RPM Learning:

1. Select Installer Software Switch 27 RPM Learning.

2. Press buttons 1 and 2 together to enter the RPM learning mode and start the 1minute

timer.

3. The siren will beep 3 times and the indicators will flash 3 times.

4. Press buttons 1 and 2 together once again.

5. The siren will beep 2 times.

6. The RPM Learning is now canceled and RPM sensing is unavailable. You can use either

the Voltage Sensing or the Generator/Oil Lamp Sensing.

Инструкция по установке

CYBORG START

СХЕМЫ ПОДКЛЮЧЕНИЯ К ЦЕНТРАЛЬНОМУ ЗАМКУ