HAWK HD 1115R — инструкция по эксплуатации моторных насосов: безопасность и использование [11/31]

Превью страниц Страница 11 / 31

Instructions Manual

Motorpumps

Cod. doc. M.I. EP-18

Issue 0

Page 11 of 31

This Manual remains the property of the Manufacturer; it may not be reproduced or copied, even partially.

2.3 Vibration

Hawk motorpumps will not produce hazardous vibrations in conditions of normal use and provided the installation and assembly

instructions in this document were carried out properly. There will be no contact with the operator during operation, as the pump

is part of the machine/system where it is fitted.

2.4 Noise

The equipment was designed and built to reduce the generation of noise at source as far as its application and method of use

allows this.

The noise measured is below the minimum level envisaged in current legal standards.

2.5 High temperatures

Mechanical parts are lubricated to prevent them overheating as a result of prolonged friction. The lubricating oil is indicated below

in this manual and takes into account the specifications of the pumps that make up the assembly. There is no probable risk

provided normal maintenance procedures are followed.

Operators should use appropriate personal protective equipment provided, including work wear and gloves.

2.6 Stability

Instructions are supplied with LEUCO pumps to ensure a stable and safe assembly on the machine/system that incorporates them.

The assembler/operator must follow these instructions carefully.

The motorpumps were designed and built so that they do not present any hazard in terms of stability in conditions of normal use.

More information is provided in section 5 “Installation”.

2.7 Pressurised liquids

The motorpumps described in this manual are built using materials that are capable of tolerating the envisaged operating

pressures. They are complete with all the necessary parts (plugs, valves, plungers, etc..) for the correct operation and circulation of

the liquids (water and lubricating oil). The lubricating transmission products contained in the pump body are used to safeguard

correct pump operation by keeping the mechanical parts lubricated.

3 SAFETY

3.1 General safety instructions

Hawk motorpumps were designed to be safe to operate for the intended purposes, provided they are run (incorporated), used and

maintained according to the instructions in these operating and maintenance instructions.

Before attempting to install or use the motorpumps, the machine operators and any other personnel involved must read and

understand the instructions provided in the manual and the project data for installation.

Do not tamper with equipment. The manufacturer is not liable in case of incorrect pump operation or for

any damage resulting from use of the product if tampering is suspected.

Before using the equipment, make sure that any safety hazard has been eliminated.

Operators must follow the safety instructions below: