Bomann GSPE 874 [27/33] Extension hose

Syphon Conn ection

Extension Hose

Ifyouneeda drainhoseextension, make sure touseasimilar drain hose.

It must b e no longer th an 4 m etres ; ot herw ise the clean ing eff ect of the di sh washer coul d be reduced .

Wa t e r O u t l e t

Connect the wate rdr ain h os e.The drain h os e mu st be cor rect ly fitte dto avoi dw at er leak s.

Ensur e t hat thew ater dra inh ose i s no t kin ked or sq uas hed .

Positioning theAppliance

I f the s i nk is 1000 h igher from the fl oor, t he exc ess w a te r i n h o se s cannot b e dr ai ne d di rec tl y

into the sink.Itwillbenecessary todrain excesswater from hosesinto abowlor suitable

conta ine r th at is held outsi de and lower th ant he si nk.

Positi on the appli anc e in the desir edlo cat ion. The back shou ld rest agai nst th ewall b ehi nd it, and the sides,

along the adj ace nt cabinet so r wall s. T hedishw asheri s equippe dw ithwater suppl yand dr ai n hoses th at c an

bepositioned either tothe righ tor the left s ides tofacilitate properinstal lation.

How to Drain Excess Water From Hoses

The wasteconnection mustbe at aheight ofbetween40cm(minimum) and100 cm(maximum)

f ro m the bott om of the dish . Th e w a t er dr ai n h ose s hould be fixe d by a hose cli p. T h e free en d of

t h e hos e mus t n ot be immerse d i n wa te r.

Ahose thatattachestoa sink spray canburst ifit isinstalledonthe same water line as thedishwasher. If yoursink

has one, it is rec ommended t hat the hose be d isconnected an d the hole plu gged .

Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.

Turn water fully on before starting the dishwasher .

Tighter the screws of the safety s upp ly hose to the faucet with thread 3/4inch.

The safe ty s upp ly hose consists of t he double wa lls.T he h ose 'ssy ste m guaran tees its inter vent i on b yb lock ing the

flow ofwater in case of thesupplyhosebreakinga ndwhen the air spacebetweenthesupply hoseitself and theouter

corrug ated h o s e is full of wa ter.

Tur n off the water .

Unscrew the safety supply hose from the faucet.

The appl iance must be conne cted to the water mai ns using new hos e-sets.

The old hose-se ts sho uld no t be reused.

Water pressure must b ebe twee n 0, 04 MPa and 1 MPa. If the pre ssu re is below the

minimumconsultourServiceDepartmentfor advice.

Conne ct the cold w ater supply hose to athr ead ed 3 /4 (in ch ) conn ector an dmake sure t hat i tis f ast ened tight ly in plac e.

If th ewater p ipes are new o rh ave not been use dfor an e xtended peri od o f t ime, let the wat er run to make sure that the

wat eris clear an dfre eof i mpuriti es. I f this precaution i s no t t aken, t here is a risk that the water inlet can get blocked

and dama ge th e ap pl ian ce.