![Haier HSU-18CKCS(R2DB) [8/8] Maximum d b w b minimum d b w b](/img/pdf.png)
Haier HSU-18CKCS(R2DB) [8/8] Maximum d b w b minimum d b w b
![Haier HSU-09HEK13/R2 [8/8] Maximum d b w b minimum d b w b](/views2/1818975/page8/bg8.png)
Trouble shooting
7
Before asking for service, check the following first.
Normal
Performance
inspection
Noise is heard
Phenomenon
Cause or check points
The system does not restart
immediately.
Smells are generated.
Mist or steam are blown out.
Multiple
check
Poor cooling
Application temp. range of air conditioner -7
o
C~43
o
C.
When unit is stopped, it won't restart
elapsed to protect the system.
When the electric plug is pulled out
and reinserted, the protection circuit
During unit operation or at stop,
a swishing or gurgling noise may
(This noise is generated by
refrigerant flowing in the system.)
During unit operation, a cracking
noise may be heard.This noise is
temperature changes.
Should there be a big noise from
filter may be too dirty.
This is because the system
circulates smells from the interior
During COOL or DRY operation,
This is due to the sudden cooling
Is power plug inserted?
Is there a power failure?
Is fuse blownout?
Is the air filter dirty?
Are there any obstacles before
Is temperature set correctly?
Are there some doors or
Is there any direct sunlight
through the window during the
Are there too much heat sources
or too many people in the room
In dry mode,
fan
speed can’t be changed.
In DRY mode, when room
than temp.setting+2
o
C,unit will
regardless of FAN setting.
Maximum: D.B
10.The appliance must be installed on a strong enough support.
9.Young children should be supervised ensure that they do not
play with the appliance.
8.The appliance is not intended to use by young children or infirm
persons without supervision.
7.The used batteries should be disposed of properly.
6.
After installation, the power plug should be easily reached..
5.The wiring method should be in line with the local wiring standard.
4.The distance between the indoor unit and the floor should be
more than 2m.
3. If the fuse on PC board is broken please change it with a fuse
type T. 3.15A/250V.
11.The wiring diagram is attached inside the machine.
2. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similar qualified
person.
The type of connecting wire is H05RN-F or H07RN-F
Cautions
The machine is adaptive in following situation
1.Applicable ambient temperature range:
Cooling
Heating
Indoor
Outdoor
Outdoor
Indoor
Maximum: D.B / W.B 32
o
C/23
o
C
18
o
C/14
o
C
43
o
C/26
o
C
18
o
C
27
o
C
15
o
C
24
o
C/18
o
C
-7
o
C/-8
o
C
Minimum: D.B / W.B
Minimum: D.B
Maximum: D.B
Minimum: D.B
Maximum: D.B / W.B
Minimum: D.B / W.B
For: T3
Cooling
Heating
Indoor
Outdoor
Indoor
Outdoor
Maximum: D.B / W.B
Minimum: D.B / W.B
Maximum: D.B / W.B
Minimum: D.B
Maximum: D.B
Minimum: D.B
Maximum: D.B / W.B
Minimum: D.B / W.B
29
o
C/19
o
C
18
o
C/14
o
C
54
o
C/24
o
C
18
o
C
27
o
C
15
o
C
24
o
C/18
o
C
-7
o
C/-8
o
C
For: T1
during cooling operation?
cooling operation?(Use curtain)
windows left open?
inlet and outlet?
Normally it should be cleaned
every 15 days.
run intermittently at LOW speed
temperature becomeslower
indoor unit may blow out mist.
of indoor air.
air such as the smell of furniture,
paint, cigarettes.
air flow in unit operation, air
generated by the casing expanding
or shrinking because of
be heard.At first 2-3 minutes after
unit start, this noise is more noticeable.
will work for 3 minutes to protect the
air conditioner.
immediately until 3 minutes have
If the fuse of outdoor unit on PC board is broken, please change
it with the type of T. 25A/250V.
Application temp. range of air conditioner -7
o
C~54
o
C.
T1:
T3:
Содержание
- Contents 1
- Operation manual 1
- Split type room air conditioner 1
- Display board 2
- Indoor unit 2
- Outdoor unit 2
- Parts and functions 2
- Remote controller 2
- Signal sending display 2
- Adjusts the fan speed according to room temperature 3
- After time setting is confirmed press set am and pm stop flashing while clock starts working 3
- Air conditioner is running under displayed fan speed 3
- Base operation 3
- Be sure that the loading is in line with the load the battery then put on the cover again 3
- Button is kept pressed time will 3
- C if kept depressed it will decrease rapidly select a desired temperature 3
- C if kept depressed it will increase rapidly every time the button is pressed temp setting decrease 3
- Change quickly 3
- Changes as 3
- Clock set 3
- Continue to press the test operation 3
- Downloaded from www manualslib com manuals search engine 3
- Fan speed selection 3
- Full display or unclear display during operation indicates the ries have been used up please change batteries if the remote controller can t run normally during operation reload several minutes later 3
- Increase or decrease 1min if the 3
- Load the batteries as illustrated 2 r 03 batteries resetting key cylinder 3
- Operation 3
- Operation starts with the air flow speed hi 3
- Please 3
- Press button every time the button is pressed temp setting increase 1 3
- Press clock button am or pm flashes press or to set correct time each press will 3
- Press fan speed button for each press fan speed follows 3
- Press mode button for each press operation mode changes as follows 3
- Press on off on the remote controller unit starts 3
- Remote controller 3
- Remove the batteries and 3
- Remove the batteries in case unit won t be in usage for a long period if there are any display after taking out just need to press reset key 3
- Room the receiver is apt to be disturbed in receivingthe signals 3
- Select operation mode 3
- Select temp setting 3
- So the distance to the indoor unit should be shorter 3
- Switch for more than 5 seconds after you hear the pi sound twice 3
- Temp temp 3
- Test operation switch is the same as emergency switch 3
- The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well 3
- Unit start 3
- Use this switch in the test operation when the room 3
- When electronic started type fluorescent lamp or change over 3
- When fan is set to auto the air conditioner automatically 3
- Wireless telephone is installed in the type fluorescent lamp or 3
- Your finger from the switch the cooling 3
- Air flow direction adjustment 4
- At air outlet if all vertical louvers are right 4
- Auto swing 4
- Cautions 4
- Conditioner 4
- Controller will automatically 4
- If the 4
- In cool dry mode 4
- In heat mode 4
- It is advisable not to keep horizontal flap at downward position for a long time in coolor dry otherwise condensate water might occur 4
- Move the vertical blade by a knob on air to adjust left and right direction referring to fig 4
- Operation 4
- Power soft operation 4
- Set swing position 4
- Set the wind speed change when sleeping 4
- Sleep operation 4
- Vertical flap 4
- When adjusting the flap by hand turn off the unit when humidity is high condensate water might occur adjusted to left or 4
- When restart after remote turning off the remote memorize the previous 4
- Wind speed is high or middle before setting for the sleep set for lowing the wind speed after sleeping if it is low wind no change 4
- For smart use of the air conditioner 5
- Healthy airflow operation 5
- Operation 5
- Timer on off on off operation 5
- And the white side face the unit 6
- Attach air purifying filter 6
- Close the grille surely 6
- Detach the standard air filter 6
- Maintenance 6
- Necessary installation 6
- Note air purifying filter is optional part 6
- Open the lnlet grille 6
- Prop up the inlet grille by using a small device named grille support 6
- Purifying filter face outside 6
- Put air purifying filter appliances into the right and left filter frames 6
- Replacement of air purifying filter 6
- Slide the knob slightly upward to release the filter then withdraw it 6
- The bacteria killing medium air purifying filter will be used for a long time no need for replacement but in the period of using them you should remove the dust frequently by 6
- Using vacuum cleaner or flaping them lightly otherwise its performance will be affected 6
- Which located in the right side of the indoor unit 6
- Caution 7
- Cautions 7
- Warning 7
- Applicable ambient temperature range 8
- Application temp range of air conditioner 7 8
- Cautions 8
- Cooling 8
- Downloaded from www manualslib com manuals search engine 8
- For t1 8
- For t3 8
- Heating 8
- Indoor 8
- Maximum d b 8
- Maximum d b minimum d b maximum d b w b minimum d b w b 8
- Maximum d b w b 32 8
- Maximum d b w b minimum d b 8
- Maximum d b w b minimum d b w b 8
- Minimum d b maximum d b minimum d b maximum d b w b minimum d b w b 8
- Minimum d b w b 8
- Outdoor 8
- Person 8
- Trouble shooting 8
Похожие устройства
- Haier HSU-13CNFR5N Инструкция по эксплуатации
- Haier HSU-18CNFR5N Инструкция по эксплуатации
- Haier HSU-13CNFG5N Инструкция по эксплуатации
- Haier HSU-18CNFG5N Инструкция по эксплуатации
- Haier HSU-18CNBW5N Инструкция по эксплуатации
- Haier HSU-18HXAR(R2DB) Инструкция по эксплуатации
- Haier HSU-09HEG03/R2(DB) Инструкция по эксплуатации
- Haier HSU-12HEG03/R2(DB) Инструкция по эксплуатации
- Haier HSU-18HEG03/R2(DB) Инструкция по эксплуатации
- Haier HSU-24HEG03/R2(DB) Инструкция по эксплуатации
- Haier HSU-09HEK03/R2(DB) Инструкция по эксплуатации
- Haier HSU-12HEK03/R2(DB) Инструкция по эксплуатации
- Haier HSU-18HEK03/R2(DB) Инструкция по эксплуатации
- Haier HSU-24HEK03/R2(DB) Инструкция по эксплуатации
- Haier HSU-09HEA03/R2-I Инструкция по монтажу
- Haier HSU-12HEA03/R2-I Инструкция по монтажу
- Haier HSU-18HEA03/R2-I Инструкция по монтажу
- Haier HSU-09R04 Инструкция по эксплуатации
- Haier HSU-12R04 Инструкция по эксплуатации
- Haier HSU-18R04 Инструкция по эксплуатации