Haier MVAH042MV2AA [2/24] User manual
![Haier MVAH048MV2AA [2/24] User manual](/views2/1820495/page2/bg2.png)
Contents
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
This equipment should not be used or serviced by personnel who have not been properly trained in its operation and
maintenance.
Children should be supervised to ensure that they do not play with the appliance.
The appliances are not intended to be operated by means of an external timer or separate remote-control system.
Keep the appliance and its cord out of reach of children less than 8 years.
Warning
MRV series multi zone air conditioning systems can operate multiple indoor units in heating or cooling. When in cooling,
only units set to cool will run. Same logic applies for heating..
Turn power on for 12 hours prior to start-up to allow the crankcase heater adequate time to protect the compressor. All
indoor units on the same refrigeration system should use the unified power switch to
ensure that all indoor units are all powered on during system operation.
Your air conditioner may be subject to any change owing to the improvement of Haier products.
Parts and Functions
1
Safety
2
5
Fault Checkup
6
Installation Procedures
13
Electrical Wiring
19
Test Run & Fault Code
4
Maintenance
Product Features
1.Function of central control (optional from our company);
2.Automatic display of fault detection;
3.The air conditioner is provided with the function fo compensation for power supply.During operation,when the power supply
fails emergently and resumes again,the air conditioner returns to the working condition before power failure,if provided
with compensation function.
4.Now this indoor unit only has wired controller function,the indoor unit that has remote controller function need to set in
factory especially.
User Manual
Содержание
- Indoor unit operation installation manual 1
- Contents 2
- Electrical wiring 2
- Fault checkup 2
- Installation procedures 2
- Maintenance 2
- Parts and functions 2
- Safety 2
- Test run fault code 2
- User manual 2
- Warning 2
- Indoor unit 3
- Parts and functions 3
- Safety 4
- Safety 5
- Maintenance 6
- Fault checkup 7
- Installation procedures 8
- 2 if necessary make a hole for installation and inspection on the ceiling used for the situation with a ceiling 9
- 3 install the 3 8 m10 hanging bolts in order to support the weight of the unit use barb bolts in the situation with a ceiling in the situation with the new ceiling use inlaid bolts embedded bolts or other parts provided on site before proceeding the installation adjust the gap between the bolt and the ceiling 9
- 4 installation of indoor units fix the indoor unit with the hoisting stud if necessary the machine can be hanged on the beam with bolts instead of the hoisting stud 9
- Adjust the level with a level meter or according to the following ways 9
- Adjusting the level 9
- For the size of the inspection hole on the ceiling please refer to the above drawing before installation finish all the preparations for all piping connected to indoor units refrigerant water drainage and wiring connection line of the line control connection line between indoor units and outdoor unit so that they can be connected with indoor units right after installation for the inspection hole the ceiling might be reinforced to keep the evenness of the ceiling and avoid the vibration of the ceiling for details please consult the construction contractor 9
- Installation procedures 9
- Make the adjustment as shown in the figure 9
- Note when the sizes of the main unit don t match the hole on the ceiling regulate the slot on the hanging bracket 9
- Preparation before installation 1 unit height is 11 inches 9
- Unit iwc 9
- A to prevent water flowing back into air conditioner when the unit stops running drain hose should decline to the drainage side with an inclination of above 1 100 drain hose expansion or water accumulation should be prevented or else it will cause abnormal noise 10
- B please use the accessory drain hose to connect indoor unit s water outlet and pvc pipe use snap rings to tighten them as shown in the following figure 10
- Drainpipes mvah009 030mv2aa 10
- Improper piping 10
- Installation procedures 10
- Mvah036 048mv2aa 10
- Proper piping 10
- Unit in 10
- Installation procedures 11
- Installation procedures 12
- Installation procedures 13
- Installation procedures 14
- Electrical wiring 15
- Electrical wiring 16
- Electrical wiring 17
- Electrical wiring 18
- Electrical wiring 19
- Code setting of wired controller 20
- Electrical wiring 20
- Function switches 20
- The difference between master and slave wired controller 20
- Test run fault code 21
Похожие устройства
- Haier MVAH048MV2AA Инструкция по эксплуатации
- LEO 4XRm4/14-1,1 Инструкция по эксплуатации
- LEO 4XRm4/14-1,1 Каталог
- LEO 4XRm4/14-1,1 Сертификат
- LEO 4XR4/14-1,1 Инструкция по эксплуатации
- LEO 4XR4/14-1,1 Сертификат
- LEO 4XR4/14-1,1 Каталог
- LEO 4XRm4/18-1,5 Инструкция по эксплуатации
- LEO 4XRm4/18-1,5 Сертификат
- LEO 4XRm4/18-1,5 Каталог
- LEO 4XR4/18-1,5 Инструкция по эксплуатации
- LEO 4XR4/18-1,5 Сертификат
- LEO 4XR4/18-1,5 Каталог
- LEO 4XRm4/24-2,2 Инструкция по эксплуатации
- LEO 4XRm4/24-2,2 Сертификат
- LEO 4XRm4/24-2,2 Каталог
- LEO 4XR4/24-2,2 Инструкция по эксплуатации
- LEO 4XR4/24-2,2 Сертификат
- LEO 4XR4/24-2,2 Каталог
- LEO 4XR4/32-3 Инструкция по эксплуатации