Haier AB142ACBFA [16/27] Installation procedures

(3) Install a suspending bolt

To support the unit weight ,anchor bolt should be used in the case of

the existing ceiling. For new ceiling, use flush-in type bolt, built-in

type bolt or parts pretared in the field.

Before going on installing, adjust the distance to ceiling.

3. Installation of indoor unit

In case of no ceiling

Install unit temporarily

Put suspending bracket on the suspending bolt to hang the unit up. Be sure to use nut and

washer at both end of the breaket to secure firmly.

After installation on the ceiling

(1) Adjust unit to its right position (Refer to preparation for installation-(1))

(2)Check that unit is horizontal.

Put suspending bracket on the suspending bolt to hang the

unit up.Be sure to use nut and washer at both end of the

bracket to secure it firmly.

Water pump and floating switch is installed inside indoor unit,check four corners of the unit for

its lever using horizontal comparator or PVC tube with water.(If unit is tilting against the direction

of water drainage,problem may occur on floating water leakage.)

In the case of existing ceiling

(1)Install unit temporarily

(2)Adjust the height and position of the unit.

(3)Proceed with procedure (4) of " In the case of no ceiling "

Nut (Prepare in feild)

Washer (Prepared in feild)

Suspending bolts

Fasten (double nuts)

Insert

Washer fixing pad

(prepared in feild)

[ secure the washer firmly]

leveler

Polythene pipe

Note: All the above mentioned parts shall be prepared in feild,

the diameter of suspending bolt is M10

Ceiling

Roof

Anchor bolt

Long nut or thread

Suspending bilt M10

50 ~150mm

Installation Procedures