![Philips PicoPix Micro 2 PPX340/INT [14/20] Service](/img/pdf.png)
Philips PicoPix Micro 2 PPX340/INT [14/20] Service
![Philips PicoPix Micro 2 PPX340/INT [14/20] Service](/views2/1822493/page14/bge.png)
14 Philips · PicoPix Micro 2
7 Service
Built-in battery care
The capacity of the built-in battery diminishes
with time. You can prolong the life of the
battery if you observe the following points:
• Without a power supply, the projector
operates on the built-in battery. When the
battery does not have sufficient power, the
projector turns off. In this case connect the
projector to the power supply.
• Charge the battery regularly. Don’t store
the projector with a completely discharged
battery.
• If the projector is not used for several
weeks, discharge the battery a little by
using the projector before storing it.
• Keep the projector and the battery away
from sources of heat.
• If the projector cannot be charged after
connecting to the power supply, use a small
pin to press the reset key (a small hole) next
to the DC socket on the projector.
Note about deep discharge of battery
When the built-in battery is in deep discharge,
it may take longer for the actual charging
process to start. In this case, charge the
projector for at least five hours before using it.
DANGER!
Risk of explosion with incorrect type
of batteries!
Do not try to replace the built-in
battery yourself.
Cleaning
DANGER!
Instructions for cleaning!
Use a soft, lint-free cloth. Never use
liquid or easily flammable cleansers
(sprays, abrasives, polishes, alcohol,
etc.). Do not allow any moisture to
reach the interior of the projector.
Do not spray the projector with any
cleaning fluids.
Wipe over the surfaces gently. Be
careful that you do not scratch the
surfaces.
Cleaning the lens
Use a soft brush or lens cleaning paper for
cleaning the lens of the projector.
DANGER!
Do not use any liquid cleaning agents!
Do not use any liquid cleaning
agents for cleaning the lens, to avoid
damaging the coating film on the lens.
Update software
The latest software of the projector can be
found on www.philips.com/support for you
to get the best features and support from the
projector.
Before you update the software of the
projector, check the current software version:
• Press on the remote control to access
the settings menu then navigate to SW
Version.
CAUTION!
Do not turn off the projector or remove
the USB flash drive during the update.
Update software through USB
1 Check the latest software version on www.
philips.com/support. Find your product
(model number: PPX340, and locate
‘Software and drivers’.
2 Download the zipped software file, then
unzip and save it in the root directory of the
USB flash drive.
3 Connect the USB flash drive to the USB port
on the projector.
• Recommend to use an external power
for software update to ensure enough
power supply.
Содержание
- User manual 1
- Www philips com support 1
- Appendix 17 2
- Change settings 12 2
- Connect 7 2
- General safety information 4 2
- Introduction 3 2
- Operation 8 2
- Other features 11 2
- Overview 5 2
- Service 14 2
- Table of contents 2
- About this user manual 3
- Customer service centre 3
- Dear customer 3
- Introduction 3
- Symbols used 3
- What s in the box 3
- General safety 4
- Information 4
- Repairs 4
- Setting up the product 4
- C b a d e f g 5
- H i j k l 5
- Overview 5
- Power supply 5
- Rear view 5
- Front view 6
- Remote control 6
- Side view 6
- Connect 7
- Hdmi connection for image projection 7
- Usb c connection for image projection 7
- Charge the projector 8
- Connect power supply 8
- Operation 8
- Operation by built in battery 8
- Operation by external power 8
- Place the projector 8
- Caution 9
- Change screen size 9
- Image shape correction 9
- Image sharpness adjustment 9
- Power on and set up 9
- Prepare the remote control 9
- Set up the language 9
- Front ceiling 10
- Front table 10
- Place the projector on a table in front of the projection screen this is the most common way to position the projector for quick setup and portability 10
- Placement options 10
- Rear table 10
- Using tripod 10
- You can install the projector in the following configurations follow the guidelines below for different projector placement 10
- Listen through external speakers or headphones 11
- Other features 11
- Rear ceiling 11
- Change settings 12
- Charge a usb device 12
- Input source selection 12
- Language settings 12
- Use easy link 12
- Use hdmi arc function 12
- Other settings 13
- Picture settings 13
- Power control settings 13
- Restore default settings 13
- Sound settings 13
- Built in battery care 14
- Caution 14
- Cleaning 14
- Cleaning the lens 14
- Service 14
- Update software 14
- Update software through usb 14
- Power cycling 15
- Troubleshooting 15
- Appendix 17
- Technical data 17
- Canada regulatory compliance 18
- Ce statement 18
- Fcc statement 18
- Other notice 18
Похожие устройства
- Vodotok БЦПЭ-65-0,4-20м Инструкция по эксплуатации
- Vodotok БЦПЭ-65-0,4-32м Инструкция по эксплуатации
- Vodotok БЦПЭ-65-0,4-45м Инструкция по эксплуатации
- Vodotok БЦПЭ-65-0,4-55м Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-16м Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-16м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-25м Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-25м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-85-0,5-25м Инструкция по эксплуатации
- Vodotok БЦПЭ-85-0,5-25м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-100-0,5-32м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-32м Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-32м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-85-0,5-32м Инструкция по эксплуатации
- Vodotok БЦПЭ-85-0,5-32м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-100-0,5-40м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-100-0,5-50м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-40м Инструкция по эксплуатации
- Vodotok БЦПЭ-75-0,5-40м-Ч Инструкция по эксплуатации
- Vodotok БЦПЭ-85-0,5-40м Инструкция по эксплуатации