Pandora DX-46 Smart Moto v2 — user Manual for Smart Device Programming and Pairing [39/48]

USER MANUALPANDORA SMART MOTO V2

Level №0 – Entering a level

After entering programming mode, the system waits for level input – “Level 0 Entering a level”.

Enter a desired level using the VALET button (see the programming table) to change settings

or parameters:

• To enter a level, press the VALET button the number of times equals to the desired level number,

pauses between presses should not exceed 1 second. The system will confirm correct input with red

LED flashes and short sound signals of the siren/beeper and proceed to the desired level.

• For quick access to the higher level, press and hold the VALET button. The siren will sounds tone

beeps (up to 10). These sounds means the sequence number of a two-digit level number (the first

signal – level №10, the fifth signal – level №50, the tenth signal – level №100). Release the VALET

button immediately after the desired number of signal. To enter an intermediate level (Level

№11…№19 or №21…№28), press the VALET button the number of times equals to the second digit

(1…9) of the desired level number immediately after releasing the button. The system will confirm

correct input with red LED flashes and short sound signals of the siren/beeper and proceed to the

desired level.

Level №1 – Pairing control devices

Prepare to pair all Bluetooth devices - install batteries, turn on the devices in accordance with their

manuals. All previously paired devices will be removed when you pair new devices (tags and remote

control are in separate memory cell, so if you pair a new radio tag, the previously paired remote control

will be not removed and vice versa). Devices are paired one by one, in any order and without time limit.

Enter the programming level №1, the LED will be green:

• To pair a remote control, press and hold 3 buttons of a remote control (arm/disarm/F) simultaneously

for 1 second (until a short beep), then release the buttons;

• To pair a radio tag, press the control button on a tag and hold it for 6 seconds (6 flashes of the tag

status indicator), release the button after the sixth flash;

- If pairing of any device was successful, the siren/beeper will sound a beep

- Press the VALET button once to pair the next device or to finish pairing (the LED indicator will

confirm it with the series of green and red flashes and the beeper will confirm it with the series of sound

signals), the system will go to the programming level №0.

Level №2 – Changing the Service PIN-code

Prepare a new value of the “Service PIN-code, it should consist of 4 digits (from 1 to 9). Write down

or remember the new PIN-code.