FERM JSM1014 [7/128] Assembly
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

FERM JSM1014 [7/128] Assembly

FERM JSM1014 [7/128] Assembly
7
EN
7. Saw shoe
8. Locking bolt for parallel guide
9. Dust extraction connection
10. Grip
11. Allen key
12. Allen key holder
ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the saw blade (fig. B)
Refer to the table below to select the required saw
blade.
Saw blade Material
Coarse Wood
Medium Wood
Fine Steel, aluminium, plastic
Very fine Wood (curves)
Do not attempt to remove the guard from
the machine.
Mounting
• Slacken the Allen screw (13) using the Allen
key (11).
• Insert the saw blade (14) in the saw blade
holder (6) as far as possible. The teeth of
the saw blade (14) must point upward and
forward. The smooth side of the saw blade
must engage in the slot of the guide roller (15).
• Tighten the Allen screw (13) using the Allen key
(11).
Removing
• Slacken the Allen screw (13) using the Allen
key (11).
• Remove the saw blade (14) from the saw blade
holder (6).
• Tighten the Allen screw (13) using the Allen key
(11).
Mounting and removing the parallel guide
(fig. C)
The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
• Slacken the locking bolts (8).
• Insert the parallel guide (16) into the saw shoe (7).
• Set the parallel guide (16) to the required
position.
• Tighten the locking bolts (8).
Removing
• Slacken the locking bolts (8).
• Remove the parallel guide (16) from the saw
shoe (7).
• Tighten the locking bolts (8).
USE
Switching on and off (fig. A)
• To switch on the machine, press the on/off
switch (1).
• To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
• To switch off the machine, release the on/off
switch (1).
Setting the sawing speed (fig. A)
The speed adjustment wheel is used for setting
the sawing speed. The speed adjustment wheel
can be set to 6 positions. The ideal sawing speed
depends on the profile and the teeth of the saw
blade and on the material to be worked.
Do not set the sawing speed during use.
• Turn the speed adjustment wheel (3) to the
required position.
• For hard materials, use a saw blade with fine
teeth and select a lower speed.
• For soft materials, use a saw blade with coarse
teeth and select a higher speed.
Setting the mitre angle (fig. D)
The mitre angle is variable between 0° and 45°.
Do not set the mitre angle during use.
• Slacken the Allen screws (17) using the Allen
key (11).
• Tilt the saw shoe (7) to the required position.

Содержание

Похожие устройства

Скачать