P.I.T. PIW1050-C [5/19] Rules of operation

P.I.T. PIW1050-C [5/19] Rules of operation
2. Gearbox case 5. Reverse switch
3. Speed controller 6. Brush assembly
RULES OF OPERATION
Preparation and start
Install the required tool (head) on the shaft (1).
Note! The product is equipped with a tool retainer that holds the head piece during operation and
carrying. For removal / installation, a certain force must be applied.
Note! For installation on the product, use only heads suitable for impact operation. The product is
switched on by pressing the on/off control (4).
Press the corresponding key (5) depending on the desired direction of rotation (screwing in/unscrewing).
When screwing in/unscrewing fasteners, the rotational moment is set using the controller (3).
Note! When screwing in, do not turn off the product immediately when the fastener stops in the part;
when unscrewing, wait for at least the specified time before unscrewing.
The product has a high rotational moment. Always hold it FIRMLY with both hands during operating.
During breaks or at the end of operation, turn off the product by releasing the on/off control (4). In the
process of intensive work, the gearbox case and the working head are heated. Do not touch them
immediately after operation and until completely cooled down.
MAINTENANCE
1. At the end of operation, remove the tool from the output shaft (1).
2. Clean the tool from dust, dirt with a clean rag. Do not use solvents or petrochemicals to clean plastic
parts.
3. Clean the replacement accessories, fixings.
4. Periodically check the tightening of all threaded connections of the tool and, if necessary, tighten all
loose fastenings.
IMPACT WRENCH
1
2
3
4
5
6
4

IMPACT WRENCH Technology 2 Gearbox case 3 Speed controller 5 Reverse switch 6 Brush assembly RULES OF OPERATION Preparation and start Install the required tool head on the shaft 1 Note The product is equipped with a tool retainer that holds the head piece during operation and carrying For removal installation a certain force must be applied Note For installation on the product use only heads suitable for impact operation The product is switched on by pressing the on off control 4 Press the corresponding key 5 depending on the desired direction of rotation screwing in unscrewing When screwing in unscrewing fasteners the rotational moment is set using the controller 3 Note When screwing in do not turn off the product immediately when the fastener stops in the part when unscrewing wait for at least the specified time before unscrewing The product has a high rotational moment Always hold it FIRMLY with both hands during operating During breaks or at the end of operation turn off the product by releasing the on off control 4 In the process of intensive work the gearbox case and the working head are heated Do not touch them immediately after operation and until completely cooled down MAINTENANCE 1 At the end of operation remove the tool from the output shaft 1 2 Clean the tool from dust dirt with a clean rag Do not use solvents or petrochemicals to clean plastic parts 3 Clean the replacement accessories fixings 4 Periodically check the tightening of all threaded connections of the tool and if necessary tighten all loose fastenings 4