Karcher SCP 5000 [15/170] Troubleshooting

Karcher SCP 5000 [15/170] Troubleshooting
English 15
Troubleshooting
Caution
To avoid risks, all repairs and replacement of spare parts may only be carried out by the authorised
customer service personnel.
Fault Cause Remedy
Pump runs but does not
transport
Air in the pump Plug in/ pull out the mains plug
of the pump a few times till the
fluid gets sucked
Suction area blocked Pull out the mains plug and
clean the suction area
(only in manual mode) Water level
below the minimum water level
Where possible, immerse the
pump deeper into the liquid or
proceed according to the in-
structions in the chapter de-
scribing the preparations
necessary for automatic oper-
ation
Pump does not run or sud-
denly comes to a standstill
during operations
Power supply interrupted Check fuses and electrical
connections
Thermal protection switch has
switched off the pump due to over-
heating
Pull out the mains plug, let the
pump cool down, clean the
suction area, prevent dry run-
ning
Dirt particles have got jammed into
the suction area
Pull out the mains plug and
clean the suction area
Pump operation stopped by sensor Check position of level sensor
Pumping capacity is reduc-
ing
Suction area blocked Pull out the mains plug and
clean the suction area
Pumping capacity too low The pumping capacity depends on
the flow height, hose diameter and
hose length.
Keep max. flow height, see
technical data. If necessary,
select a different hose diame-
ter or hose length.

Содержание

Скачать