Denzel RH-650-18 [10/28] Rotary hammer
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Denzel RH-650-18 [10/28] Rotary hammer

Denzel RH-650-18 [10/28] Rotary hammer
9
ROTARY HAMMER
EN
MAINTENANCE
ATTENTION!
Before starting maintenance and adjustment of the Electrical Rotary Hammer unplug the power cord
from the power outlet. To ensure quality and safe functioning keep your tool and vents clean at all times.
• If you notice a decrease in impact energy, working tool speed of rotation or extraneous noise, it is necessary to
hand over the punch to the service center for its repair.
• Working tool maintenance. The use of the worn working tool reduces the eectiveness of the work and may
result in motor or gearbox failure, so you need to sharpen periodically or replace worn removable tools, as soon
as there is a need.
• Electric motor care. You must be especially careful with the electric motor, avoid getting liquids and objects
inside the case. Keep your ventilation holes clean, blow them regularly with compressed air or clean them with
a brush. When noticeable sparks appear, contact an authorized service center for diagnostics and replacement
of carbon brushes if necessary.
• To prevent dust and grease leakage this Electrical Rotary Hammer has a hermetic design. Therefore, the tool
can be used for a long time and you have no need to replace or add grease. After initial commissioning change
lubrication every 6 months of operation.
• Every time after use clean the tool holder box.
• In case of any damage to the power cord turn o the Electrical Rotary Hammer immediately, carefully, without
touching the places of damage, disconnect it from the mains.
ATTENTION!
Electrical Rotary Hammers use power cord with mounting type Y: for security it must be replaced by
authorized repair shop personnel.
Possible faults
Fault Probable cause Problem solution
When turning on the Electrical
Rotary Hammer, there is no
impact or rotation of the tool.
Damaged gear or impact mechanism. Call the service center.
At turning on on, the electric
motor does not work (line
voltage available).
Damaged switch or plug.
Call the service center.
Broken power cord or mounting wire.
Brush or collector malfunction.
Circular re on the collector.
Damage in the armature winding.
Call the service center.
Wearout /”hang ” of brushes.
Increased noise in the gear or
impact mechanism.
Wearout / breakage of the mechanism parts. Call the service center.
When working smoke or smell
of burning insulation is goes
out from the vent
Interturn closure of armature or stator
windings.
Call the service center.
Malfunction of the electrical part of the
instrument.
Tooling is not xed or not
extracted from the box.
Damaged device of the tooling mount. Call the service center.
The use of low-quality tooling. Use high-quality tooling

Содержание

Похожие устройства

Скачать