Denzel HG-1800 [8/28] Installation removal of nozzles
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Denzel HG-1800 [8/28] Installation removal of nozzles

Denzel HG-1800 [8/28] Installation removal of nozzles
8
HOT AIR GUN
EN
OPERATION
Installation / removal of nozzles
ATTENTION!
When installing, removing, replacing equipment, keep in mind that nozzles and tool nozzle
become very hot. Careless handling of the tool when changing the nozzle can cause burns or
damage to surrounding objects.
In the delivery set there is a set of nozzles, which is shown in the pic. 4. It is designed to facilitate the work with the
device in various situations.
Nozzles are installed on the nozzle of the hot air gun with little eort. If necessary it is recommended to bend the
landing ring of the nozzle to ensure reliable attachment of nozzles.
Power connection
ATTENTION!
Power tools should only be connected to single-phase AC power, the voltage of which
corresponds to the voltage indicated on the rating plate located on the tool housing. If the
rating plate indicates a voltage of 230V, then the power tool can also be switched on to a main
with a voltage of 220 V.
When working outdoors use industrial extension cords intended for outdoor use. Do not use homemade
extensions. When working outdoors connect power tools to the power circuit equipped with a dierential
automatic with a response current of not more than 30 мА, this will reduce the risk of electric shock.
When connecting ensure that the insulation of the electrical cable and the power plug of the machine is intact.
Make sure the machine's power switch is in the “o” position.
This power tool can be connected to power outlets that do not have a protective ground, since it has double
insulation (protection class II).
Air supply speed and temperature mode adjustment
Depending on the type of material being heated and the type of work you can choose the optimal air ow rate
and temperature. Adjustment is carried out from minimum to maximum value by selecting working mode 5
(рiс. 1) and on models HG-2000M, HG-2000E by temperature controller 3 (рiс. 1). Data with the characteristics is
presented in the table 1.
For model HG-1800
Switch the operation mode switch 5 to one of three positions:
I – 250 l / min air supply is ensured at a temperature of 50 °С. This mode is used to dry and cool the hot air gun
before turning it o after working in other modes.
II – 250 l / min air supply is ensured at a temperature of 450 °С.
III – 500 l / min air supply is ensured at a temperature of 550 °С.
For model HG-2000M
Switch the operation mode switch 5 to one of three positions:
I – 250 l / min air supply is ensured at a temperature of 50 °С. This mode is used for drying various items and
cooling the air gun before disconnecting after working in other modes.
II – 250 l / min air supply is ensured at a temperature of 50-600 °С.
III – 500 l / min air supply is ensured at a temperature 50-600 °С.
When switching to modes II and III, the temperature is adjusted by turning the dial 1 (рiс. 2). Numbers printed on
the disc indicate the level of the set temperature – a higher number corresponds to a higher temperature from the
range specied in Table 1. Numbers indicate exclusively the positions of the adjustment dial and do not reect the
temperature of the exhaust air, expressed in degrees.

Содержание

Похожие устройства

Скачать