Denzel AG180-2000 [12/32] Angle grinder

12

ANGLE GRINDER

EN

•

If you notice a decrease in the frequency of rotation of equipment or extraneous noise during operation, it is

necessary to hand over the device to the service center for its diagnosis and repair.

•

Working tool maintenance. The use of the worn working tool reduces the eectiveness of the work and may

result in motor or gearbox failure, it is therefore necessary to periodically replace worn out tooling as soon as

To prevent dust and grease leakage this machine has a hermetic design. Therefore, the tool can be used for a

long time and you have no need to replace or add grease. After initial commissioning change lubrication every 6

months of operation. To replace the lubricant, contact the service center.

places of damage, disconnect it from the mains.

Fault Probable cause Problem solution

Circular re on the collector.

Fault in the armature winding. Call the service center.

Wearout /”hang ” of brushes. Call the service center.

Increased noise in the gear.

Wearout / breakage of the

mechanism parts.

Call the service center.

When working smoke or smell

of burning insulation is generated

from the vent.

Interturn closure of armature

Wearout / breakage of gears

or bearings.

Call the service center.

Faulty or improperly installed

tooling.

Replace or reinstall a tooling.

and other laws of the country, where the tool is operated.