Sinbo SSI-2885 Инструкция по эксплуатации онлайн [11/62] 84035

- 10 -

USING THE APPLIANCE

Filling the water into detachable water tank

Make sure that there is enough water in the water tank. (Fig.2)

Note: Don’t put hot water, perfume, vinegar, starch, descaling agents, ironing aids or other

chemicals in the water tank.

1. Remove the detachable water tank from the steam generator. (Fig.1)

Note: Detach the water tank and fill it at any time during use.

2. Fill the water tank with tap water up to the MAX indication.

Note: If the water in your area is very hard, we advise you to mix it with an equal amount of

distilled water.

3. Slide the water tank back into the steam generator. (Fig.3)

4. Make sure that the water tank is firmly attached to the steam generator.

Note: Don’t tilt or shake the steam generator when the water tank is full, otherwise water may

spill out of the filling hole.

Note: Fill the water tank before first use and as soon as the ‘no water alarm’ indicator is on.

No water alarm indicator

When the water tank is almost empty, the ‘no water alarm’ indicator(M-2) is on and steam

ironing is no longer possible.

1. Shut off the power switch.

2. Remove the water tank and fill it.

3. Put the water tank back into the steam generator till its clicks place, the iron is ready for

steam ironing again.

Dry ironing function

1. Place the steam generator on a stable and level surface, e.g. on the hard part of the ironing

board or on a table.

2. Put the mains plug in an earthed wall socket and press the on/off button to switch on the

steam generator?the dry iron function is on normally, the dry iron indicator (M-1) is on at the

same time?and you can dry iron after 2 minutes.

Boiler heating function and Steam ironing

1. Place the steam generator on a stable and level surface, e.g. on the hard part of the ironing

board or on a table.

2. Put the mains plug in an earthed wall socket and press the on/off switch (on the control

panel), the ‘dry iron’ indicator starts flashing(M-1), press the boiler heating button(M-7) to shift

to steam ironing( The ‘dry iron’ stop flashing ), the boiler heating indicator(M-4) starts flashing.

After 2.5 minutes, the steam ready indicator (M-3) flashes, it shows that the steam is ready.

Note: If you want to shift from ‘boiler heating’ to ‘dry iron’, you press the ‘boiler heating’ button

again, then the ‘boiler heating’ indicator and ‘steam ready’ indicator turns off, the ‘dry iron’

indicator is on, the dry iron is ready.

3. To set the required ironing temperature, turn the temperature dial to the appropriate position.

(Fig.4)

4. Turn the power knob to the desired steam setting to switch on the appliance. Make sure the

steam setting is suitable for the selected ironing temperature. (Fig.5)

5. Press the steam trigger(C) and keep it pressed while you steam iron. (Fig.6)