Sinbo SSI-2885 Инструкция по эксплуатации онлайн [13/62] 84035

Sinbo SSI-2885 Инструкция по эксплуатации онлайн [13/62] 84035
- 12 -
TROUBLESHOOTING
This chapter summarizes the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
The appliance does
not function
There is a connection problem. Check the mains cord, the plug
and the wall socket.
The appliance is not switched on. Set the power knob.
The appliance does
not produce any
steam
There is not enough water in the
water tank.
Fill the water into water tank.
The steam generator is not hot
enough to produce steam
Wait until the steam ready
indicator stays on.
The steam output control dial is
set to the minimum.
Increase the steam output (control
dial on the control panel)
Water droplets
come out of the
soleplate
When you start steam ironing and
when you continue steam ironing
after an interruption, the steam
that was still present in the hose
has cooled down and condensed
into water. This causes water
droplets to come out of the
soleplate.
This is normal. Hold the iron over
an old cloth and press the steam
trigger. The cloth absorbs the drops.
After a few seconds, steam instead
of water comes out of the soleplate.
The temperature dial is set to a
temperature that is too low for
steam ironing.
Set an ironing temperature that is
suitable for steam
ironing(temperature settings xx to
MAX).
Wet spots appear
on the garment
during ironing
The wet spots that appear on your
garment after you have steam
ironed for some time may be
caused by steam that has
condensed onto the ironing board.
Iron the wet spots without steam
for some time to dry them. If the
underside of the ironing board is
wet, wipe it dry with a piece of dry
cloth.
Flakes and
impurities come out
of the soleplate or
the soleplate is dirty
Impurities or chemicals present
in the water have deposited in the
steam vents or on the soleplate.
Clean the soleplate with a damp
cloth.
Too much scale and minerals
have accumulated inside the
steam generator.
Rinse the steam generator
frequent.
Water tank is full of
water, but ‘no water
alarm’ indicator is
always on.
The water tank is not properly
placed.
Make sure that the water tank is
firmly attached to the steam
generator.
Problems Causes Solutions

Содержание

Скачать