Sinbo SF-6708 [7/31] Assembly of blade and guard

- 6 -

ASSEMBLY OF BLADE AND GUARD

1. Un-screw to remove the blade spinner from the motor shaft .

2. Un-screw the guard mounting nut from the front of the motor housing.

3. Position the rear guard against the front of the motor housing with the handle uppermost,

ensuring that the locating pegs on the motor housing are engaged correctly in the holes

in the guard.

4. Screw the guard mounting nut firmly onto the projecting thread on the motor housing,

make sure you tighten it firmly.

5. Remove and discard the PVC sleeve on the motor shaft.

6. Place the fan blade onto the motor shaft, locating the slot at the back of the blade on

the drive pin that pass through the motor shaft.

7. Screw the spinner onto the motor shaft, and tighten it firmly against the front of the

blade.

8. Position the front guard against the rear guard so that the holes in the rims that accept

the small nut and bolt are in line. Insert the bolt through the holes and screw on the

nut. Do not fully tighten at this stage.

9. Move the guard retaining clips into position ensuring that they engage correctly on the

rim of the guard.

10. Fully tighten the small nut and bolt that passes through the rim of the guard.

Operating instructions

1. Plug the power cord into a suitable socket

2. Tilt the head up or down to the required position by using a locking mechanism that

will hold the head in the desired position.

3. The fan is switched on using the push buttons on the base, i.e.

0 = Off, 1 = Low Speed, 2 = Middle speed, 3= High speed.

Oscillation Control

1. Push the oscillation knob to oscillate

2. Pull the oscillation knob to stop

Special Attention:

1. If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualified persons in order to avoid a hazard.

2. This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of the appliance by a

person responsible

for their safety

3. Children should be supervised to ensure that they do not play with the appliance.