Graco Reactor E-20 FH9030 — установка и подключение датчика температуры жидкости и шлангов [22/42]

Превью страниц Страница 22 / 42

Setup

22 312065V

RELIEF/SPRAY valves, Route hose back to

component A and B drums. See FIG. 1, page 12.

2. Alternately: Secure supplied bleed tubes (N) in

grounded, sealed waste containers (H). See FIG. 2,

page 13.

Install Fluid Temperature Sensor

(FTS)

The Fluid Temperature Sensor (FTS) is supplied. Install

FTS between main hose and whip hose. See Heated

Hose manual 309572 for instructions.

Connect heated hose

NOTE: See Heated Hose manual 309572 for detailed

instructions on connecting heated hoses.

NOTE: The fluid temperature sensor (C) and whip hose

(D) must be used with heated hose, see page 22. Hose

length, including whip hose, must be 60 ft (18.3 m)

minimum.

1. Turn main power OFF .

2. Assemble heated hose sections, FTS, and whip

hose.

3. Grease with Fusion grease and connect fluid hoses

to proportioner fluid manifold (M): red for hardener

(ISO, blue for resin (RES).

NOTE: The manifold hose adapters (N, P) allow use of

1/4 in. (6.4 mm) and 3/8 in. (9.5 mm) ID fluid hoses. To

check adapter tightness, torque 1/4 in. and 3/8 in. ID

hoses to:

• A side (HA) to 14 ft-lb (19 N•m).

• B side (HB) to 20 ft-lb (27 N•m).

NOTE: To use 1/2 in. (13 mm) ID fluid hoses, remove

the adapters (N, P) from the proportioner fluid manifold

and install them in the FTS or 3/8 in. ID hose inlets.

Torque 1/2 in. ID hoses to:

• A side (HA) to 43 ft-lb (58 N•m).

• B side (HB) to 55 ft-lb (74 N•m).

WLD

NOTE: For proportioners with a termination box (TB),

follow step 8d. For proportioners with electrical splice

connectors (v), follow step 5.

TI10954a