Sencor SPT 226 R [12/16] Troubleshooting

EN - 10

Troubleshooting

If a fault occurs, ﬁ rst check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following hints, consult your dealer or service center.

Note: Do not open the unit as there is a risk of electric shock. Under no circumstances should you

try to repair the set yourself; as this will invalidate the guarantee.

No power

• Ensure that the power cord connect securely.

• Ensure that there is power at the AC Mains.

• Ensure that the batteries are inserted correctly.

No sound or poor sound

• Adjust the volume.

No response from the unit

• Disconnect and reconnect the AC power cord, then turn on the unit again.

• Electrostatic discharge, re-connect the AC power cord after a few seconds.

CD does not play

• The disc is dirty. Clean the CD.

• The disc is placed upside down. Remove and place the CD right side up.

• Use a ﬁ nalized CD or correct format disc.

The CD skips tracks

• Ensure that the CD is not damaged or dirty.

• Ensure that program mode is deactivated.

Poor radio reception

• Electrical interference in your home can cause poor reception. Move the unit away from them

(especially those with motors and transformers).

• Fully extend the telescopic antenna.

The unit does not function properly while using batteries

• Batteries are dead. Replace the new batteries.

• The polarities of the batteries are incorrectly positioned.

• Reinsert the batteries ensuring the polarities (+/-) match the unit’s indicated polarities (+/-).

File from MP3 disc does not play

• Check the ﬁ le format. This product only support MP3 format.

Remarks:

• If the unit is not used for 30 minutes or more, it will automatically enter STANDBY mode.

Press the PROGRAM/RESTART button to resume use.

• If any anomaly occurs, switch the FUNCTION Selector to OFF position, and then switch it

back to CD/MP3 or FM ST. position again.