Sencor SFH 9013 [4/6] Ceramic heater

CERAMIC HEATER LU SFH 9013 OPERATION OF DEVICE First connect the power cord into a power outlet with the correct voltage Ensure that the device is located on an even and stable surface Main switch on the back side of the device To turn on the device move the main switch to position A sound will be produced which means that the device is ready for use To turn off the device move the button to position 0 Touch sensor control panel with LED display Touch sensor Ensure that the main switch is in position I Touch the sensor with symbol Q and the relevant indicator will turn on The device will start with low power 1300 W By touching the sensor again you will bring the device to stand by mode Note the device will be in operation for approximately 30 seconds before it goes into stand by mode The relevant indicator will turn off Touch sensor setting the power output If you touch the sensor marked with the symbol you will increase the power output to 2500 W 2500 will be displayed on the LED display By pressing the sensor again the device will switch back to low power output and the display will display 1300 Touch sensor S oscillation This function enables the automatic turning of the body of the device from side to side When the device is in operation touch the sensor marked with the symbol The body of the device will start to automatically turn from side to side At the same time the relevant indicator will be on By pressing the sensor again the turning function will be turned off and the relevant indicator will turn off Do not set the direction of air flow by turning the body of the device by force relative to the base of the device If the direction of airflow does not suit you hold the device by the hadle and turn the entire device including the base according to your requirements Make sure not to entangle the power cord Touch sensor setting the timed shut off This function serves to automatically turn off the device after duration of the set time While the device is in operation touch the sensor marked with the symbol Q and the device will switch into timer setting mode The automatic shut off timer may be set in the range from 00 30 to 07 30 With each press of the button the time will be extended by half an hour At the same time the set time will be displayed on the display The device will automatically shut off after the duration of the set time REMOTE CONTROL Open the battery cover on the back side of the remote control Insert 2 alkaline AAA 2 x LR03 2 x 1 5 V batteries When inserting the batteries ensure that their polarity is correct There are 4 buttons on the remote control and their functions are the same as those on the control panel If you wish to use the remote control point the remote control at approximately the level of the control panel with the display The maximum signal range of the remote control is 6 m If you place the remote in such a way that the transmission of the signal is blocked by barrier the signal may not be transmitted at all The safety function of the automatic shut off when the device overheats If you tilt the device you will hear a click sound This is due to the in built safety device which serves to automatically turn off the device when it is tilted If the during operation the device is tilted by approx 45 the safety function is activated and the device will shut off If the device falls over then this function serves as protection against the creation of a dangerous situation EN 4 Copyright 2012 Fast CR a s Revision 05 2012

Скачать
Случайные обсуждения