Karcher VC 6300 [13/178] Changing the attachments in the quick click attachment housing

Karcher VC 6300 [13/178] Changing the attachments in the quick click attachment housing
- 3
sition on the back of the appliance, and
push it into the resting position.
Illustration
To remove, press handle backwards in
the direction of the appliance. The floor
nozzle is thus unlocked from the parking
holder and can be removed upwards.
Illustration
Hold the power cord at the plug and pull it
out. Insert the mains plug into a socket.
Turn on/off the appliance.
Illustration
The power suction adjustment is at the
power suction control:
+ push button (A), higher power suction
- push button (B), lower suction power
Adjust the suction power to suit the suc-
tion requirement:
Low suction power – for laced curtains,
textiles, upholstered furniture, cushions
Medium suction power – for slightly dirty
carpets/ carpeted floors, precious carpets,
bridges and runners
Highest suction power – for hard floors,
very dirty carpets and carpeted floors
It is advisable to use the Stand-by key (C)
during short breaks in cleaning:
Press the Standby key, the appliance
switches off, the LED on the appliance
glows to indicate the standby mode.
Press the Stand-by key again to resume
work.
Note: After pressing the stand-by key, the
vacuum cleaner runs at the vacuum set-
ting that had been set earlier.
Important notice! The appliance will shut-
down automatically, if there is danger of over-
heating. Turn the appliance off and pull the
power plug. Make sure, that the nozzle, the
suction pipe or the tube is not clogged, failing
all the above the filter must be changed. After
the elimination of the interference let the ap-
pliance cool down for a minimum of 1 hour,
before using it again.
Upholstery nozzle: for cleaning uphol-
stered furniture, mattresses, laced cur-
tains, etc.
Furniture brush, rotating: for cleaning
furniture and delicate objects with care,
dusting books, air vents in the car, etc.
Joint nozzle, detachable: for edges,
joints and heaters
Hang in the floor nozzle in the park holder
on the rear side of the machine and press
it into locking position (see illustration 4)
Illustration
Push the dead button at the handle and
remove the telescopic suction pipe.
Illustration
Open the attachment housing cover.
Illustration
Insert the handle in the desired accessory
until the stop. It then gets locked. Then tilt
it downwards and pull it out.
Illustration
To store, put the attachment using the
handle into the attachment housing and
click it up into place. Remove the handle.
Notice: You also can remove the attach-
ment manually and put it on top of the
handle. In order to release the attach-
ment, push the dead button on the handle.
Notice: All steps stated above can also be
done when the telescopic suction pipe is
connected. Hang the floor nozzle on the
backside of the appliance into the parking
holder, and push into the pause position.
Pull the telescopic suction pipe straight
up.
Illustration
Carpets and carpeted floors:
Select the following switch setting:
Suction using accessories
QuickClick attachment
QuickClick Using the attachments
Changing the attachments in the Quick-
Click attachment housing
ComfoGlide nozzle
9EN

Содержание