Home
Главная
Electrolux
Варочные Панели
EHG 6815 X
Руководство по эксплуатации Страница: 16

Electrolux EHG 6815 X [16/76] Electrical connection

Electrolux EHG 6833 [16/76] Electrical connection

16 electrolux

The appliance is designed to be

connected to 230 V monophase

electricity supply.

The connection must be carried out

in compliance with the laws and

regulations in force.

Before the appliance is connected:

1) check that the main fuse and the

domestic installation can support the

load (see the rating label);

2) check that the power supply is

properly earthed in compliance with the

current rules;

3) check the socket or the double

pole switch used for the electrical

connection can be easily reached with

the appliance built in the forniture unit.

The appliance is supplied with a

connection cable. This has to be

provided with a proper plug, able to

support the load marked on the

identification plate. To connect the plug

to the cable, follow the recommendation

given in Fig. 3a. The plug has to be fitted

in a proper socket.

If connecting the appliance directly

to the electric system, it is necessary

that you install a double pole switch

between the appliance and the

electricity supply, with a minimum gap

of 3 mm. between the switch contacts

and of a type suitable for the required

load in compliance with the current

rules.

The connection cable has to be

placed in order that, in each part, it

cannot reach a temperature 50°C

higher than room temperature.

The brown coloured phase cable

(fitted in the terminal block contact

marked with "L") must always be

connected to the network phase.

Electrical Connection

Remplacement of the voltage

cable

The connection of the voltage cable

to the appliance's terminal block is of

type "Y". This means that its

replacement requires the specific

equipment of a technician. In this case,

only cable type H05V2V2-F T90 must

be used. The cable section must be

suitable to the voltage and the working

temperature. The yellow/green earth

wire must be approximately 2 cm.

longer than the phase wires (Fig. 3-a).

To open the terminal block and reach

the terminals, proceed as follows:

z insert the point of a screwdriver into

the visible protrunding part of the

terminal block;

z exert a light pressure and lift (Fig. 3-b)

Fig. 3-b

Earth

(yellow/green))

Neutral

Fig. 3-a

Содержание

Похожие устройства