Aten CS1964 [7/16] Open close

CS1964 RS-232 Commands

Open / Close

The Open and Close commands allows you to start and end the link between

the computer sending RS-232 commands and the CS1964. When the link is

open, the CS1964 only accepts RS-232 commands and will not respond to front

panel pushbuttons, mouse switching and hotkeys. The link starts with the open

command and ends with the close command or after 2 minutes if no command

is sent. The default value is close.

Note: To regain full control of front panel pushbuttons, mouse switching, and

hotkeys, close the RS-232 link command and slide the DCC Switch to

the P position (Primary).

Use the Formula - to set Parameters - to create a Command.

Formulas:

Command + [Enter]

Parameters:

Open/Close RS-232 Link Command

The available formulas for the Open/Close RS-232 Link commands are as

follows:

1. Command + [Enter]

For example, to open the RS-232 link between the computer and CS1964, type

the following:

open [Enter]

2. Command + [Enter]

For example, to close the RS-232 link between the computer and CS1964, type

the following:

close [Enter]

Command Description

open Open RS-232 Link command

close Close RS-232 Link command

Enter Description

Enter Enter and send out command