Aten RBS Configurator [3/5] Supported commands

2. Click Open. This window appears and a connection is established.

3. To execute help, read, or reboot command, type the command in the command-line

interface.

To execute an echo command, i.e. to monitor the RBS panel and receive notifications for

management actions carried out on the RBS panel, go to the next step.

See Supported Commands for full information on commands.

4. To monitor the RBS panel by using the echo command, do the following.

(a) In the command-line interface, type echo on ↙ to allow the RBS panel to send feedback

messages to the controller.

Note: Remain on the Port 6262 connection.

(b) In the chosen controller’s setup page, use Port 7373 for monitoring.

 Host Name: Specify IP address of the RBS panel to which you wish to connect

 Port: 7373

Supported Commands

Echo

Usage:

To notify the controller of the management action carried out via the RBS panel. Refer

to the table below for the management actions and the corresponding feedback

message.

Action Feedback Message

Check-in action = check-in

Check-out action = check-out

Manual room release action = release

Auto room release when the reservation

time is up

action = auto-release

Room reservation action = reserve

Reservation extension action = extend