SNR S2989G-24TX-POE Руководство по настройке онлайн [23/553] 747270

Превью страниц Страница 23 / 553

S2989G-24TX Operation Manual

Chapter

Basic

Management

Configuration

1-8

3) If 2) is not met, HTTP client should connect to an IPv4/IPv6 address of the switch via

other devices, such as a router.

Similar to management the switch via Telnet, as soon as the host succeeds to

ping/ping6 an IPv4/IPv6 address of the switch and to type the right login password, it can

access the switch via HTTP. The configuration list is as below:

Step 1: Configure the IP addresses for the switch and start the HTTP server function on

the switch.

For configuring the IP address on the switch through out-of-band management, see

the telnet management chapter.

To enable the WEB configuration, users should type the CLI command IP http server

in the global mode as below:

Switch>enable

Switch#config

Switch(config)#ip http server

Step 2: Run HTTP protocol on the host.

Open the Web browser on the host and type the IP address of the switch, or run

directly the HTTP protocol on the Windows. For example, the IP address of the switch is

“10.1.128.251”;

Figure 1-9 Run HTTP Protocol

When accessing a switch with IPv6 address, it is recommended to use the Firefox

browser with 1.5 or later version. For example, if the IPv6 address of the switch is

3ffe:506:1:2::3. Input the IPv6 address of the switch is http://[3ffe:506:1:2::3] and the

address should draw together with the square brackets.

Step 3: Login to the switch.