Al-Ko BC 4535 II Premium [16/266] Assembly

Al-Ko BC 4535 II Premium [16/266] Assembly
Translation of the original operating instructions
16
Assembly
Parts overview (Fig. 1)
1 Cutting blade
2 String head
3 Guard
4 “Bike” grip
5a/5b Gas lever
6 Engine ON / OFF switch
7a/7b Gas lever lock
8 Shoulder strap
9 Air lter shroud
10 Petrol tank
11 “Choke” – “Run” lever
12 Primer (cold-start diaphragm pump)
Caution!
The machine must not be operated before assembly
work has been completed.
Mounting the handgrip.
“Bike” grip (Fig. 2A, B)
1. Place the rubber sleeve (3) over the shaft.
2. Fasten the lower brace (2) and the center piece (4)
using the four Allen screws (1).
3. Place the grip rod (5) into the grip holder and fasten
with the upper brace (6) and the four Allen screws (7).
Mounting the guard (Fig. 5)
1. Place the metal plate (2) under the guard (3).
2. Fasten to the support bar with 4 screws (1).
The cutter integrated into the guard automatically shortens
the cutting string to the optimal length.
Mounting the string head
1. Remove the cotter pin (Fig. 4-4) and ange (Fig. 4-3).
2. Insert an Allen key (Fig. 6-2) into the hole in the drive
plate (Fig. 6-1) and screw the string head onto the
guide pin of the drive shaft.
(Caution: left-hand thread!)
3. Lock the drive plate (Fig. 6.1) with the Allen key in or-
der to mount the string head.
Mounting the cutting blade.
1. Remove the smaller half shield from the guard
(Fig. 5 ).
2. Remove the cotter pin (Fig. 4-4) and ange (Fig. 4-3).
3. Place the cutting blade on the drive plate in such
a way that the hole in the cutting blade is exactly
aligned with the guide circle of the drive plate.
4. Push the ange (Fig. 4-3) onto the cutting blade so
that the at side faces the cutting blade.
5. Secure the clamping nut on the guide pin. To do this,
insert the Allen key (Fig. 4-5) into the hole provided
and tighten. (Caution: left-hand thread!)
6. Secure the nut with the cotter pin.
Adjusting the shoulder strap (gures A-E)
1. Push the shoulder strap over your left shoulder.
2. Hook the locking hooks into the eyelet.
3. Check the length of the shoulder strap by making a
number of swinging movements without switching on
the engine.
The string head or cutting blade must move parallel
to the ground.
Caution!
Always use the shoulder strap when working with the
device.
Only hook up the shoulder strap once the engine is
started and idling.
Caution!
Use only original cutting knives and accessories!
Non-original parts can cause injury or impairment to the
device!

Содержание

Скачать