Home
Главная
LINE 6
Антенна
XD-AD8 Splitter
Руководство по эксплуатации Страница: 6

LINE 6 XD-AD8 Splitter [6/12] Electin

Setting up AntennAS

The XD-AD8 allows multiple wireless receivers to share a single pair of remote antennas, achieving the

same RF signal level and isolation possible with individual pairs of remote antennas connected to each

receiver.

•Mount the XD-AD8 in a rack.

•Attach one end of a BNC-to-BNC antenna cable (provided with the digital wireless

microphone system) to position 1 of the

Antenna A Distribution Connectors on the rear

panel, and attach the other end to the

Antenna A input on the digital wireless receiver.

•Attach a second BNC-to-BNC cable similarly between position 1 of the

Antenna B

Distribution Connectors, and then to the Antenna B input on the same receiver.

•Continue in this manner for the other digital wireless receivers.

•Attach the BNC cable / connector from a remote antenna (P180 directional or P360

omnidirectional) to the

In A BNC connector on the rear panel – the stand-alone BNC

connector on the left side of the XD-AD8. The antenna will be mounted remotely in line-

of-sight with the area where the transmitters will be used. Attach the second remote antenna

similarly to the stand-alone In B connector on the right.

•Attach the IEC power cable to the XD-AD8 and to a 90V – 260V, 50 or 60 Hz AC power

source.

•Turn on the

Power switch on the front panel; the blue LED will light when the unit is on.

•Check that the power LEDs are lit on the P180 or P360 remote antennas.

SeleCting Front or reAr AntennAS

Antenna connections are provided on both the front and rear panels of the XD-AD8, with a selector

switch that determines which connection is active. Remote antennas will typically be connected to

the rear panel

In A and In B connectors, but also can be connected to the front panel. Articulating

half-wave antennas, such as the ones supplied with the Line 6 wireless receivers, can also be used on the

front panel connectors.

•When using remote antennas, connect them to the rear panel

In A and In B BNC connectors,

especially for more permanent installations, as they will be more protected.

•For convenience in portable applications, remote antennas may also be attached to the

Front

Antenna A and B BNC connector.

•Position the front-panel

Antenna Select switch appropriately to Back or Front, depending on

where the antennas are connected.

•If you are using a pair of articulating half-wave antennas supplied with the wireless receivers,

attach them to the front-panel connectors and position in a “rabbit ear” conﬁguration. Slide

the switch to

Front, and make sure the XD-AD8 is positioned near the top of the rack and the

antennas are line-of-sight with the transmitters for the best performance.

Note, Connecting antennas to both front and rear antenna inputs at the same time is not recommended.

Note, When viewing the XD-AD8 from the rear, antenna In A is on the left and In B is on the right.

This placement corresponds with the front-panel connector placement of

A on the right and B on the

left.

LINE 6 XD-AD8 Splitter [6/12] Electin

Содержание

Похожие устройства