American Audio Encore 1000 [15/33] General functions and controls cont front rear panel

GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL

©American Audio® - www.AmericanAudio.us - Encore 1000 Instruction Manual Page 15

35. LINE 2 INPUT JACKS - DO NOT CONNECT TURNTABLES TO THESE JACKS! CD players, Tape

Decks and other line level instruments may be connected to these jacks. The red colored RCA jack

represents the right channel input and the white represents the left channel input. Input volume will

be controlled by channel two fader. The channel SOURCE SELECTOR SWITCH (17) must be in the

"Line 2" position, to monitor any source connected to these jacks.

36. REC OUT - This is a low current unbalanced output source designed for various tape and CD

recorders. The Record Out (REC OUT) level is dictated by the CHANNEL FADER LEVEL (22), it is not

inuenced by the MASTER VOLUME CONTROL (28).

37. RCA MASTER OUTPUTS - The RCA jacks send a low current unbalanced output signal. These

jacks should only be used for shorter cable runs to signal processors or looping to another mixer.

For cable runs greater than 15 feet use the XLR BALANCED JACKS (38).

38. BALANCED XLR MASTER OUTPUT JACS - The Master Output includes a pair of XLR

Balanced jacks as well as a pair of RCA UNBALANCED JACKS (37). The 3-pin XLR jacks send a

high current balanced output signal. These jacks should be used when you will be driving an amp or

other audio equipment with a balanced input, or whenever you will be running a signal line greater

than 15 feet. Always, use these jacks whenever possible.

39. POWER BUTTON - This button is used to turn your unit’s power on and off.

40. POWER CONNECTOR - This connection is used to connect your main power. Be sure that your

local power matches the unit’s required power. NEVER REMOVE THE GROUND PRONG FROM

THE POWER CABLE, DOING SO MAY RESULT IN IMPROPER OPERATION.