TRAYNOR K1CE [5/18] Channel 2

Channel 2

5. Mic

This female-XLR connector accepts any standard dynamic microphone, low or high impedance.

6. Mono Input

Connect a mono, line or instrument-level source here (balanced or unbalanced). This could

include an acoustic/electric guitar with, or without a preamp built-in.

Note: Ideally channel 2 works best with a single source connected either to the Mic or Mono

Input however, both inputs can be used at the same time with no problems (the Mic signal has a

certain amount of priority to be slightly louder, if the guitar does not have an onboard preamp.

7. Gain

The Gain control regulates Channel 2’s volume and mix-level with the other channels.

8. Bass and Treble

These controls regulate the low and high-frequency response of Channel 2. Center setting is

neutral. Turn clockwise or counter-clockwise for up to 15dB of boost or cut. As with all active

tone controls, boosting or cutting affects the gain of the channel, hence large adjustments

may require re-adjustment of the Gain control.

Channel 3

9. Mon(itor) Input

This input, when used, turns the K1 into a personal stage monitor capable of mixing the rest

of the performances with yours through the K1’s amp/speaker system. Connect a balanced or

unbalanced patch cable here coming from the line level (not speaker-level) output of a mixer.

Note: This channel’s signal goes directly to the internal amp/speaker system and is not

present at the Bal. Line Out, Stereo Phones or Link Out jacks. It is also post-Master, which

means it is adjusted independently by its own Gain control, but not the Master.

10. Gain

The Gain control regulates Channel 3’s volume and mix-level with the other channels

through the amp/speaker system (see above Note).

Master Section

11. Master Control

This control regulates the overall volume of channels one and two plus the L and R Aux

Inputs through the built in amplifier and speakers plus the headphones. It does not regulate

the Bal. Line Out on Mon(itor) In.

12. L and R Aux. Inputs

Connect your MP3, CD or tape player to these RCA inputs. Other optional input sources

could include a stereo guitar preamp (*Pod®, **Sansamp®, etc.). Aux. input signals go to the

Bal. Line Out as well as the Stereo Phones jack, the Link Out jack and of course the internal

amp/speaker system.

13. Bal. Line Out

Connect your K1 to the PA or recording mixer with a balanced patch cable plugged in here.

The mix from this output is mono thus you only need to connect it to one mixer channel. It is

also pre-Master level control (i.e. not controlled by the MASTER) and does not carry any of

Channel 3’s signals (See above under Channel 3 Mon(itor) Input).

As with all balanced ¼-inch connectors, the TRS (stereo) plug connections are;

Tip = “+”, Ring = “-“ and Sleeve = ground. Also, see Note 1 under Link Out.