Al-Ko SnowLine 560 II [26/283] Adding fuel and engine oil

Al-Ko SnowLine 560 II [26/283] Adding fuel and engine oil
GB
Translation of original user instructions
26
AL-KO snow blower
4. Insert the guide plates into the discharge chute
frombeneathandtightenwiththeself-lockingnuts
(
12-1).
5. Repeat the procedure for the other two guides
x The snow discharge chute is attached.
Attaching snow discharge chute hand crank
1. Removethehandlefromthecrankbyremoving
themountingscrew(
13).
2. Insertthehandcrankfromthehandlesidefrom
below into the guide on the guide handle (
14).
3. Removethesafetysplitpinandwasherunderneath
using pliers (
15).
4. Insert the hand crank into the lower guide on the
snow discharge chute. The snow discharge chute
mustbepositionedsuchthatthespiralofthehand
cranktsintothegroovesofthechute(
16-1).
Ifitisdifcultorimpossibletomovethehandcrank
tothelowerguide,itmaybenecessarytoadjust
the upper guide. To do this, loosen the screws
slightly and re-tighten after adjusting (
14-1).
5. Attach the washer and insert the safety split pin
using pliers (
17-1).
6. Bend the ends of the safety split pin (
18).
7. Screw the handle onto the crank (
19).
x The hand crank is attached.
Checking the tyre pressure
The maximum allowed tyre pressure is indicated on
the tyres (
20-1).Note:1bar=approximately14.5psi
Pumpupbothtyrestothesamepressurelevelusingthe
tyrepump.
Attaching the headlight (620E II)
1. Insertthepre-assembledheadlightfromthefront
throughtheguidehandleusingthemountingscrew
(
21-1).Donottwistordamagethecable!
2. Fasten the headlight using the washer and self-
locking nut.
3. Fasten the cable to the guide handle using cable
clips.
x The headlight is attached.
Adding fuel and engine oil
Always follow the instructions in the engine
operatingmanualprovided.
Fuel the snow blower and add oil before use.
Danger - re hazard!
Petrolandoilarehighlyammable!
Fuel and lubricant
Petrol Engine oil
Type Regular lead-free
petrol (86 octane
or higher)
Engine is E10-
compliant.
SAE 5W-30
recommended
Filling
quantity
Seeenginemanual

Содержание

Похожие устройства