Timberk THU UL 30 E (MP) [6/28] Cleaning and maintenance

Timberk THU UL 30 E (MP) [6/28] Cleaning and maintenance
www.timberk.com • electric humidifier
6
the --- button to turn off this function.
Timer to turn off the device
To set the timer time to turn off the device, press the button --- several times,
and the set timer time before the device is switched off will be reflected on
the display from 1 to 24 hours, in increments of 1 hour. Within 3 seconds
after setting, the set value will be memorized and will be displayed on the
display. The device will switch off after the set time interval has elapsed.
Turning off the instrument or setting the timer value [0] will cancel the timer
to turn off the device.
Automatic operation mode
In automatic operation mode, the steam output intensity will be adjusted
automatically. If the relative humidity level is less than 40%, the humidifier
will operate with a high steam output rate. If the relative humidity is between
40% and 60%, the humidifier will operate at an average steam output rate.
If the relative humidity level is more than 60%, then the humidifier will work
with a low vapor yield. To turn this mode on and off, press the --- button.
When this button is pressed, the mode is switched on / off, the automatic
mode indicator will light up / go out on the control panel.
Disabling the light indication
In this mode, the display backlight and the light indication of the operating
modes around the control panel are turned off. To activate this mode,
press and hold the --- button for 3 seconds. To turn off this mode, press
any button.
Automatic shut-off in the absence of water
If the water level in the tank drops below the minimum permissible level,
the ultrasonic membrane of the device will automatically turn off, an audible
signal will sound, the indicator will not light on the display, and the light
indication of the modes around the control panel will glow red.
To continue the operation of the device it is necessary to fill the reservoir
with water according to item 6 «Filling the reservoir with water», then
connect the device to the electrical network.
Sound notification
When the appliance is switched on and off, and when the buttons are
pressed, a beep is emitted.
Switching off the device
To turn off the device, press the button --- and disconnect the device from
the mains.
IMPORTANT!
To avoid deformation or wear of working surfaces,
resulting in decreased atomizing or other malfunctions, do
not use metallic brushes, blades or talc powder to wipe
the atomizer’s surface. The water tank may leak upon
heavy impacts. In case of water leakage, immediately
stop using the unit and contact a service center. To keep
the unit dry, remove water after cleaning and make sure
to dry the unit’s case. Make sure that there is no water left
inside the unit’s case. Prior to a long break in using the
unit, dry its surface and pack it into a plastic bag, then
put it into a box. Store the unit in a low-humidity room.
Storing the unit undried results in generation of mold
7. CLEANING AND MAINTENANCE
Before cleaning the device make sure that the plug is disconnected from
the wall outlet. Otherwise, it may result in electric shock. Before cleaning,
wait until the cooling water in the ground, so as not to burn your hands.
Spend device cleaning once or twice a week. To clean the outer surface of
the unit with a damp soft cloth. To avoid electric shock, do not scratch or
damage the device while cleaning elements.
Do not use when cleaning the device thinner, benzene, dimethyl benzene,
stiff brush, talcum powder and other materials, except water.
Wipe any remaining water inside the base with a damp, soft cloth.
To remove the remaining water in the small details, you can use a soft
brush, then wipe it again with a soft cloth.
In the formation of dirt on the membrane, clean it with a soft brushes. Use
a soft brush to erase the remnants of water on the surface of the device,
and then wipe it again with a soft cloth. Rinse water tank and a clean water
dispenser.
After removal of the residual water from the surface of the sprayer, wipe it
with a soft cloth. Clean the outside surface with a damp, soft cloth.

Содержание

Скачать