Snaige FR 27SM-PRC30F310 [5/12] Do not install this appliance in areas that are too humid or too colds such as the construction appendices garages or wine cellars place the appliance away from heat sources such as kitchen stove oven radiators or direct sunlight the appliance must not touch any pipes for heating gas or water supply or any other electrical devices

INSTALLATION AND OPERATING CONDITIONS OF THE

APPLIANCE

Positioning:

• This appliance can be installed in a dry, well ventilated indoor where the ambient

temperature corresponds to the climate class indicated on the rating plate of the

appliance.

Do not install this appliance in areas that are too humid or too colds, such as

the construction appendices, garages or wine cellars. Place the appliance

away from heat sources such as kitchen stove/oven, radiators, or direct

sunlight. The appliance must not touch any pipes for heating, gas or water

supply, or any other electrical devices.

Minimum distances from the heat sources:

- from the electric gas and other ovens - 30 mm,

- from oil or coal fired ovens - 300 mm,

- from built-in ovens - 50 mm

If there is no possibility of ensuring the above- mentioned distances, provide an

appropriate insulation board.

• Do not cover the ventilation holes at the top of the appliances – it

must be a good air circulation around the appliance. There should

be a gap of at least 10 cm between the top of the appliance body

and any furniture that may be above it. If this requirement is not

followed, the appliance consumes

more electrical energy and its

compressor may overheat. 

• The appliance must stand on a level

surface and must not touch the

wall. If necessary, regulate the

height of the appliance by adjusting

the levelling feet: by turning them

clockwise – the front of the appliance rises, by turning

them counter clockwise – it comes down. If the

appliance is tilted slightly backward – the doors will close

by themselves.

• If you are positioning the refrigerator in a corner, leave

a gap of at least 1 cm between the wall and the body of

the appliance so that the refrigerator door opens enough

to enable the fruit and vegetable tray to be pulled out.

• Preparing for operation:

• It is recommended to prepare the appliance for operation with a helper.

• Remove package. Lift the appliance away from foamed polystyrene base. Tear off

adhesive tapes. Remove all red-coloured parts from the shelves and coloured adhesive

tapes from the door trays

• When placing, moving, lifting the appliance, do not hold the door handles, do

not pull the condenser at the rear part of the refrigerator and do not touch

the compressor unit.