Luxstahl MARCO Qwikbrew-6 [5/8] Brewing

1900057 REV.3 5

BREWING

HOT WATER OPERATION

Approx. 5.7L of water is available as an immediate draw-off; after this no water is available until

the machines heat fill cycle has recovered. This is to ensure that any water drawn off is at the

correct temperature.

BREWING OPERATION

1. A brew can be selected any time the green ‘Ready to brew’ light is illuminated.

2. Slide out the coffee filter bowl and place a single sheet of filter paper in the bowl.

3. Put the desired amount of ground coffee into the filter paper. Your coffee supply company

may have pack sizes to suit the brews of your Qwikbrew 2.

Depending on the coffee grind and roast, and on water quality, you may have to adjust

these quantities to obtain the optimum flavour.

4. Level off the surface of coffee by gently shaking the filter bowl.

5. Slide the coffee filter bowl into the guide rails in the brew head and push fully home.

6. Select the correct brew on the control panel by pressing the required Brew Button.

N.B. If you make a mistake press the Power Button to turn the machine off. Wait 3

seconds and turn back on again. Select the correct brew.

7. A 3L brew should take around 4-5min. A 6L brew should take around 8-10min.

8. As soon as possible after brewing – remove the filter paper with the spent grinds.

Note: allow time for all the coffee to drain from the filter bowl before removing.

SETTING BREW WATER VOLUMES

When in volume calibration mode you are selecting the overall water flow time for each brew. The

sprayhead outputs approx 700mL/minute which is 11.66mL/second. You can select 1, 2 or all 3

brew volumes in the one calibration session, they can be selected in any order, e.g. brew 2 could

be the lowest or highest volume depending on when you press the brew 2 button. So if you want a

volume of 3.5L in brew 2 you would press 2 after 5min(=300sec), (11.66mL/sx300s=3.5L), see

table guide.

To Calibrate Volume

1. Turn the brewer on by pressing the power button.

2. Press and hold any of the brew buttons for 5+ seconds, your timer should be started the

moment you press the button down. (any brew button can be pressed to enter

calibration mode, e.g. you could press & hold brew 1 if only calibrating brew 3)

3. The power on red LED will blink to show you are in volume calibration mode, no water

will flow at this time.