Liebherr GTP 2756 Premium [4/7] Additional functions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Liebherr GTP 2756 Premium [4/7] Additional functions

Liebherr GTP 2756 Premium [4/7] Additional functions
10
Power failure display
If nA appears in the display, this means that
the freezer temperature has risen too high
during the last few hours or days due to a
power failure.
If you press the ALARM button whilst the
display is reading nA, the highest tempera-
ture registered during the power failure will
be displayed. Check the quality of the food and its suitability for
consumption in case it has become too warm or even defrosted.
The highest temperature will appear for appox. 1 minute. After that,
the actual temperature in the freezer will re-appear. The display can
be switched o by pressing the ALARM button.
Audible warning signal
The audible warning device helps to protect the frozen food and
to save energy.
- It sounds when the lid has been left open for longer than about
60 seconds; (except model GT 1456)
- It sounds when it is not cold enough in the
freezer compartment. The temperature display
will also ash.
The audible warning device is switched o by
pressing the ALARM button.
Switching the appliance on and o
You are recommended to clean the appliance before switching it
on for the rst time (see Cleaning).
To switch the appliance on: Press the ON/OFF button until the
temperature display lights up.
- The two illuminated dashes of the digital tem-
perature display will light up until a temperature
of 0°C is reached.
- If the temperature is below 0°C, the digital
temperature display will show the temperature
inside the appliance.
To switch the appliance o: Press the ON / OFF button for ap-
prox. 3 seconds so that the temperature display goes out.
Setting the temperature
• To reduce the temperature: Press the
bottom button Down.
• To increase the temperature: Press the
top button Up.
- While you are entering the temperature, the
set temperature will ash on the display.
- You can change the settings in increments
of 1°C briey pressing the button again. If the buttons are held
down the temperature setting will change faster.
- The electronic controls will switch over automatically about 5 sec-
onds after the last time you pressed the button, and the actual
temperature in the freezer will be displayed.
If F4 or F5 appears in the display, the appliance has a fault. It will be
kept at the right temperature by means of a safety circuit.
Consult your nearest customer service point.
➊ Temperature setting buttons
➋ On/O button
➌ Audible warning on/o button
➍ Child lock LED
➎ SuperFrost LED
➏ SuperFrost button
➐ Temperature display
Operating and control elements
Additional functions
Keypad lock
The keypad lock ensures that no unintentional changes are made
to the electronic control system.
Activating the keypad lock
Press for 5 seconds. Display =
Display =
Display =
Display =
Display =

Содержание

Похожие устройства

Скачать