Texas Efterh?ngt Rotorklipper [20/22] Troubleshooting
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Texas Efterh?ngt Rotorklipper [20/22] Troubleshooting

Texas Efterh?ngt Rotorklipper [20/22] Troubleshooting
DRIVE BELT REMOVAL AND INSTALLATION
1. Shut off mower and tractor.
2. Remove drive belt shield fasteners and belt shields.
3. Loosen gearbox slide plate bolts and gearbox adjustment bolt.
4. Slide gearbox to its forward most position.
5. Slide belts under the gearbox sheave (Item 7) and over the center spindle sheave (Item 8).
6. Make sure that right hand belt (Item 5) is in the lower groove of the gearbox sheave and that the
left hand belt (Item 6) is in the upper groove.
7. Slide the gearbox back to the full rear position and adjust according to the belt adjustment
procedure described above.
STORAGE
Your mower represents an investment from which you should get the greatest possible benefit and
use. Therefore, when the cutting season is over, the mower should be thoroughly checked and
prepared for storage so that a minimum amount of work will be required to put it back into operation
for the next season.
We suggest the following storage procedures:
1. Thoroughly clean the mower.
2. Lubricate the mower as recommended in the maintenance section of this manual.
3. Tighten all bolts and pins to the recommended torque.
4. Check the mower for worn or damaged parts and replace them.
5. Store the mower in a clean, dry place with the deck resting on blocks.
6. Use spray touch up enamel where necessary to prevent rust and maintain its appearance
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Streaking
1. Slow blade tip speed
2. Worn blade tips
3. Dull blades
4. Blades unable to cut the part of
grass pressed down by tractor's
tire path or mower's casters
5. Mowing too fast
6. Drive belt loose
7. Belt glazed/slipping
8. Blade loose on spindle
9. Conditions too wet for mowing
1. Operate PTO at 540 RPM
2. Replace with correct specified blades
3. Sharpen blades uniformly
4. Slow tractor's ground speed but maintain
540 RPM PTO speed
5. Slow down until cured
6. Tighten per instructions on maintenance
chapter
7. Apply belt dressing or replace it with a
correct specified belt
8. Tighten blade nut securely
9. Allow grass to dry before mowing
Grass discharges
1. Grass is too high and too coarse
1. Slow tractor's ground speed but maintain

Содержание

Похожие устройства

Скачать