Gorenje WHI641ST Starck [26/148] Charcoal filte

26

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button T3 for 3 seconds.

The suction speed (power) 1 starts functioning and button T3 ashes to indicate that hood calibration is initiated and it will last for approx.

5 minutes.

Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should therefore be repeated.

MAINTENANCE

WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the lters may cause re risks.

Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any re

damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

Grease lter

Traps cooking grease particles. The grease lter must be cleaned once a month using non aggressive detergents, either by hand or in the

dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease lter may discolour slightly,

but this does not affect its ltering capacity. To remove the grease lter, pull the spring release handle.

Charcoal lter (lter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal lter occurs after more or less prolonged use, depending on

the type of cooking and the regularity of cleaning of the grease lter. In any case it is necessary to replace the cartridge at least every four