RCF EVOX JMIX8 13000569 Руководство по эксплуатации онлайн [13/24] 776345

ENGLISH

this case the EVOX JMIX8 outputs the LEFT channel and the EVOX J8 outputs the RIGHT

channel. If the environment or the setup does not permit the correct positioning of EVOX

JMIX8 as left channel and EVOX J8 as right channel, it is possible to reverse the stereo

image using the box called SWAP LR:

SWAP LR OFF: EVOX JMIX8 LEFT – EVOX J8 RIGHT

SWAP LR ON: EVOX JMIX8 RIGHT – EVOX J8 LEFT

EQLIVE

This control enables a speciﬁc contour which is optimized for live use of musical

instruments, rather than prerecorded material. You can enable this mode at your choice.

The EQLIVE setting affects both LEFT and RIGHT outputs, therefore it is activated also

on the external EVOX J8 which may be connected to the LINK OUT XLR output; the AUX

output is not affected, unless its routing is set to Link Out mode.

A MUTE box completes the set of controls on this page. Selecting the MUTE box

interrupts the signal ﬂow through the MAIN stereo channel. The numeric window in the

lower right display corner shows the nominal level of the MAIN LEVEL knob. The small

round point on the knob scale indicates the 0.0dB level.

MAIN GEQ page: this page gives access to the 7 band Graphic EQ available on MAIN

channel. Select each single band of the EQ using the “PARAMETER SELECT” buttons

[

] and rotate the EDIT encoder to change value. A value box shows the variation in dBs

of the selected band. A dedicated box permits to turn ON and OFF the entire EQ.

AUX OUT page: this page gives access to the master level control of the AUX bus. Select

“AUX” from the ROUTING drop-down menu for the regular use of the AUX send. PRE/

POST ON/OFF box allows to derive the AUX signal before or after the channel level

control. Set this control to OFF for AUX PRE and ON for AUX POST. FX RTN ON/OFF box

permits to assign the internal effect return to the AUX bus. The MUTE box, if selected,

mutes the AUX bus output.

Select “MAIN L-R” from the ROUTING drop-down menu, permits to assign to the AUX

bus the MAIN MIX signal, summed in mono.

Select “LINK OUT” from the ROUTING drop-down menu, it allows to create an available

link connection with a further EVOX J8 from the AUX OUT balanced jack. This setting

permits to create a large EVOX setup composed by one EVOX JMIX8 plus up to three

EVOX J8. (See page 42: EVOX JMIX8 CONFIGURATION).