LINE 6 XD-V35 [8/12] Ransmitte

8

the receiver has no gain or attenuation controls.

Do not use TRS connectors with the XD-

V35 Receiver as the Ring portion of the connector is used for firmware updates and may cause

computer generated noise in your audio outputs.

Note: When the associated transmitter is off, and moderate to strong interfering frequencies not coming

from a Line 6 transmitter are present on the selected receiver channel, one or more of the RF LEDs on

the right side of

Trans Status will turn red. Higher levels of interference will light more red LEDs. Use

back; it is hinged at the base of the transmitter.

•Insert two AA batteries, noting the polarity markings shown in the battery compartment. Use

battery cover and replace the bottom section of the transmitter.

•Press and briefly hold the left button below the

Channel display to turn on. A small blue LED

will light above the currently selected channel.

•Press the right

Select button to change to the next channel; the blue LED above the number

will light. Each press of the button will go to the next channel. The channel is selected

light green.

Note: When the transmitter battery level is low, the LED over the number 6 on the display will light

calibrated for use with alkaline batteries, so when NiMH rechargeable batteries are used the remaining

life will not be as accurate – however, the basic indication is to insert fresh batteries soon after the LED

shows red. Carbon-zinc batteries are not recommended.

tBP06 BeltPack tRansmitteR detailed setuP

•With a thumbnail, slide down the latch on the battery door located on the right side of the

transmitter.

•Open the hinged door and insert two AA batteries, noting the polarity markings shown on

flash red when less than 40 minutes remain.

•On the face of the transmitter, the

channel from 1 to 6. Slide the metal button to the desired channel number; it has detents so

it will stop in the correct place. The channel is selected and active immediately.

•Connect the lavalier microphone to the 1/4” TRS (tip-ring-sleeve) jack on the bottom of the

transmitter. When you speak in the mic, the

•When the transmitter is on the same channel number as the receiver, the receiver

Trans