AUDIX D4 [2/2] Architect and engineer specifications
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

AUDIX D4 [2/2] Architect and engineer specifications

AUDIX D4 [2/2] Architect and engineer specifications
SPECIFICATIONS
Transducer Type
Dynamic
Frequency Response
40 Hz - 18 kHz
Polar Pattern
Hypercardioid
Output Impedance
280 ohms
Sensitivity
1.4 mV / Pa @ 1k
Capsule Technology
VLM Type D
Off Axis Rejection
>20 dB
Maximum SPL
≥144 dB
Power Requirements
None
Connector
3-pin XLRm
Polarity
Positive pressure on diaphragm
produces positive voltage on
pin 2 relative to pin 3 of output
XLR connector
Materials / Finish
Black Hard Coat
Weight
128 g / 4.5 oz
Length
100 mm / 3.9 in
D4
Hi
Lo
FREQUENCY RESPONSE
POLAR PATTERNS
ARCHITECT AND ENGINEER SPECIFICATIONS
The microphone shall be of the dynamic type operating on the moving
coil principle and the capsule shall be VLM Type D. The polar pattern of
the microphone shall be hypercardioid. The nominal output impedance
shall be 280 ohms at 1 kHz.The microphone shall have a sensitivity of
1.4 mV / Pa at 1 kHz and shall handle a sound pressure level of ≥144 dB.
The microphone body shall be machined of aluminum and the grill
cap shall be steel wire mesh. The overall dimensions shall be 21.5 mm in
diameter at the base, 39 mm in diameter at the widest point on the grill
and 100 mm in length.
OPERATION AND MAINTENANCE
The D4 is a low impedance microphone and should be plugged into
a “mic level” input of your console, mixer or recording device. Please
note that your microphone does not require phantom power and will
not be affected in any way by phantom power should it be running
simultaneously while the microphone is in operation. Avoid plugging
or unplugging the microphone from the PA system unless the channel
is muted or the volume of the system turned down. Failure to do so
may result in a loud “popping” noise which could seriously damage the
speakers in the PA system.
The D4 is manufactured to exacting specs with roadworthy construction.
However, the capsule is highly sensitive and should be handled with care.
Avoid extreme temperatures and be sure to store your microphone in
the pouch provided when not in use. Moisture of any kind can adversely
effect the sound and performance of your microphone.
USER TIPS
The D4 has an extremely tight hypercardioid pick-up pattern in order to
help eliminate sound from other instruments on stage from “bleeding”
into the microphone. For this reason, the D4 is exceptionally effective
for drums and percussion in it’s ability to capture the sound of each
component of the kit.
Drums, hand percussion: As a general rule, the bottom of the D4 grill
should be 1-2 inches above the head of the drum and pointed towards
the center. For more “ring” pull the mic back towards the rim; for less ring
and more overtones, position the mic 1-2 inches inside the rim; for more
attack, place the mic very close to the head; for more overtones and
decay move the mic further away from the head.
Guitar cabinets: The D4 can be placed within 1-2 inches off the grill
cover at a 90 degree angle pointing directly at the speaker. If the mic is
placed closer to the edge of the speaker, you will minimize the higher
frequencies and get a warmer, fatter tone. To capture more highs, move
the mic closer towards the center of the speaker.
Horns: Place the mic within 1-2 inches of the bell, especially when on
a stage with drums, bass, guitar, etc. For jazz, classical, and music where
the stage volume is lower, the mic can be placed further away for a
richer, fuller sound.
Further miking techniques may be found at www.audixusa.com.
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
www.audixusa.com
503.682.6933 Fax: 503.682.7114
Audix Corporation 9400 SW Barber St. Wilsonville, OR 97070
ver 2.0 06-15
SERVICE AND WARRANTY
This microphone is under warranty for a period of 5 years to be free of defects in material and workmanship. In the event of a product failure due to materials or workmanship, Audix will
repair or replace said product at no charge with proof of purchase. Audix does not pay or reimburse shipping costs for warranty repairs or returns. The warranty excludes any causes other
than manufacturing defects, such as normal wear, abuse, environmental damage, shipping damage or failure to use or maintain the product per the supplied instructions. No Implied
Warranties: All implied warranties, including but not limited to implied warranties of merchantability and fitness for a particular purpose are hereby excluded. The liability of Audix, if any,
for damages relating to allegedly defective products shall be limited to the actual price paid by Dealer for such products and shall in no event include incidental or consequential damages
of any kind. Should your microphone fail in any way, please contact the Audix Service department at 503.682.6933. A Return Authorization is required before returning any product.
OTHER THAN THIS WARRANTY, AUDIX MAKES NO WARRANTIES, EXPRESS OR IMPLIED, WITH RESPECT TO THE PRODUCTS, THE USE OF THE PRODUCTS, THE PERFORMANCE OF THE PRODUCTS. AUDIX
SHALL NOT BE LIABLE FOR SPECIAL INCIDENTAL, CONSEQUENTIAL, INDIRECT OR SIMILAR DAMAGES ARISING FROM OR BASED ON THE SALE, USE, STORAGE OR DISPOSAL OF THE PRODUCTS, AUDIX’S
SERVICE WORK, BREACH OF WARRANTY, BREACH OF CONTRACT. NEGLIGENCE, OR ANY OTHER THEORY OF LIABILITY, EVEN IF AUDIX HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
PRODUCT REGISTRATION
Please register your product online at www.audixusa.com/docs_12/about/product_registration.shtml.
DIMENSIONS (mm)
http://acctech.ru/cat/instrumental_mikrofony/

Содержание

Похожие устройства

Скачать