Hyundai Home Assistant NX DEH2 [7/44] Condensate removal

Dehumidier

Condensate removal

In the course of air drying, the appliance shall accumulate the condensate (water recovered

from air). As soon as the condensate tank is full, the TANK FULL indicator will ash on and the

appliance will stop working. In order to resume working it is necessary to remove the tank and

pour water (see a scheme below).

The appliance may also work in constant mode without the necessity of occasional pouring of

water from the tank. For that the user should insert a special drainage hose (not included in

the delivery set) into a special aperture for constant condensate removal and direct water to a

prepared tank or drainage system (see a scheme).

Fig. 3 Fig. 4

NOTE:

1. If the moisture level in the room is 3% lower than the one set by

the user, the compressor will stop working. As soon as air moisture

level exceeds the set one by 3%, the compressor wick start working

again.

2. If the Tank Full indicator is ashing on, it is necessary to pour water

from the tank.

3. The drier will stop working, if the set moisture level is higher than

the current air moisture level in the room.

4. Range of operating temperatures for this appliance is 5-32°С

5. If the drier does not work (the Power indicator does not ash on) or

if the appliance makes long pauses in its work, wait for 10 minutes

and then try to turn it on again. If the appliance will not resume

working, refer to a shop assistant or to a service center.

6. If the appliance is turned o, it can be turned on only in 3 minutes.

The view is to protect the compressor from damaging.

7. If the Defrost indicator is ashing on, it means that the evaporator

has supercooled and needs automatic defrosting. In this mode

the compressor will stop working and the fan will continue its

operation.