Al-Ko Robolinho 4100 I [57/400] Start up

Al-Ko Robolinho 4100 I [57/400] Start up
457296_b 57
Start-up
The boundary cable is not routed properly
around corners (02/c).
The boundary cable is crossed over or not
routed clockwise (02/d).
The boundary cable is routed too imprecisely
so that edge areas of the grass surface can-
not be mowed (02/e).
The start points are set too far away from the
base station (02/f).
The boundary cable is not routed lying direct-
ly next to itself when guided towards and
back from the edge to an obstacle inside the
lawn (02/g).
The boundary cable is routed beyond the
edge of the grass surface (02/h).
When routing the boundary cable, the mini-
mum distance for corridors of 30cm is under-
cut (02/i).
The boundary cable is routed too close (i.e.
at a distance of less than 15cm) to obstacles
that cannot be driven over (02/j).
4.6 Connecting the base station to the
power source (05)
1. Place the transformer (05/1) at a dry location,
protected from rain and spray.
2. Unwind the low voltage cable (05/3) of the
base station (05/4) and route (protected from
damage) to the site of the transformer.
3. Connecting the low voltage cable to the
transformer:
Unscrew the screws of the luster terminal
(05/2) until a wire of the low voltage cable
can be inserted into each opening.
Insert the wires.
Note:Attention does not have to be paid
to the polarity.
Screw in the screws of the luster terminal
until the wires have been securely
clamped.
4. Plug the mains connection cable (05/5) of the
transformer into the power socket.
NOTE
We recommend connecting the trans-
former to the mains supply via an earth
leakage circuit breaker (ELCB) with a
rated leakage current <30mA.
4.7 Checking the connections on the base
station (05)
1. Check that both LEDs (05/8, 05/9) light. If
not:
Disconnect the mains plug.
Check that all plug connectors of the
power source and the boundary cable
are positioned correctly and check for
damage.
2. If necessary, loosen the screws (05/7) on the
cover (05/6) of the base station and remove
the cover.
Status indications of the LEDs
LEDs Operating states
Green
(05/9)
Lights up when the boundary
cable is laid correctly and the
loop is intact.
Flashes if a loop of the bound-
ary cable is not in order.
Yellow
(05/8)
Lights up if the power source is
intact.
Flashes if the appliance is in the
base station and is being
charged.
5 START-UP
This chapter describes the activities and settings
that are necessary to put the automatic lawn
mower into operation for the first time. For all fur-
ther settings, refer to see chapter 7 "Settings",
page59.
5.1 Charging the rechargeable battery (09)
The integrated battery is partially charged on de-
livery. During normal operation, the battery of the
appliance is regularly charged automatically.
NOTE
Fully charge the rechargeable battery
before using it for the first time. The re-
chargeable battery can be charged in
any charge status. Interrupting charging
does not damage the rechargeable bat-
tery.
The rechargeable battery can only be
charged after the appliance has been
switched on.

Содержание

Похожие устройства

Скачать