Al-Ko HTA 4245 POWERFLEX [20/192] Working behaviour and working technique 06

Al-Ko HTA 4245 POWERFLEX [20/192] Working behaviour and working technique 06
GB
20 HTA 4245
Working behaviour and working technique (06)
6 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (06)
WARNING!
Increased risk of falling
There is a greater risk of falling if work is
carried out from an elevated position
(e.g. ladder).
always work with the appliance from
the ground and make sure that you
are standing securely.
Heed the safety instructions.
Cut the hedge regularly and only at the per-
mitted times.
Only cut off the thin branches and new
growth on the surface of the hedge; do not
cut too deep.
Always cut the two sides of a hedge first, fol-
lowed by the top. This prevents cut material
from falling into areas that you have not yet
trimmed.
Hedges should always be trimmed into a
trapezoidal shape (tapering toward the top).
This prevents the leaves on the lower
branches from being shaded out (06).
7 MAINTENANCE AND CARE
WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance
parts and into cutting tools.
Before maintenance, care and
cleaning work, always switch off the
appliance. Remove the recharge-
able battery.
Always wear protective gloves
during maintenance, care and clean-
ing work.
Do not get the machine wet or expose it to
moisture.
Clean plastic parts with a cloth and do not
use any cleaning agents or solvents.
Check the electrical contacts for corrosion,
clean with a fine wire brush if necessary and
then spray with a contact spray.
Check the cutting blade for damage and – if
damaged – have replaced.
Clean the cutting blade and spray with rust-
proofing oil.
8 STORAGE
Thoroughly clean the appliance after each use and
– if present – attach all covers. Store the appliance
in a dry, lockable place out of the reach of children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
Clean the cutting blade and spray with rust-
proofing oil.
Thoroughly clean the appliance and store it in
a dry place.
9 HELP IN CASE OF MALFUNCTION
CAUTION!
Risk of injury
Sharp-edged and moving appliance
parts can lead to injury.
Always wear protective gloves
during maintenance, care and clean-
ing work.
Malfunction Cause Remedy
Cutting
blade be-
comes hot
when run-
ning. Gener-
ation of
smoke.
No oil on the
cutting
blade.
1. Switch off the
appliance
and remove
the recharge-
able battery.
2. Clean and oil
the cutting
blade.
3. Insert the re-
chargeable
battery
again.
Cutting
blade is
blunt.
Nicks in
the cut-
ting
blade.
Contact an AL-
KO service cen-
tre.

Содержание

Похожие устройства

Скачать