Lincoln Navigator (1999) — как подготовить автомобиль к I/M тестированию и заменить лампы [185/216]

Превью страниц Страница 185 / 216

not pass the I/M test with the “Check Engine/Service Engine Soon” light

on.

If the vehicle’s powertrain system or its battery has just been serviced,

the OBD-II system is reset to a “not ready for I/M test” condition. To

ready the OBD-II system for I/M testing, a minimum of 30 minutes of city

and highway driving is necessary as described below:

• First, at least 10 minutes of driving on an expressway or highway.

• Next, at least 20 minutes driving in stop-and-go, city-type traffic with

at least four idle periods.

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete.

EXTERIOR BULBS

Replacing exterior bulbs

Check the operation of the following lamps frequently:

• Headlamps

• Foglamps

• High-mount brakelamp

• Brakelamps

• Turn signals

• License plate lamp

• Tail lamps

• Back-up lamps

Do not remove lamp bulbs unless they can be replaced immediately with

new ones. If a bulb is removed for an extended period of time,

contaminants may enter the lamp housings and affect lamp performance.

Replacing headlamp bulbs

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

Maintenance and care

185